Abstract:As a main measure to promote the development of China’s energy–saving and new energy vehicles, the Phase V fuel consumption regulation is dramatically different from the past four phases, especially in the test procedure, moving from the New European Driving Cycle (NEDC) to the worldwide harmonized light duty test cycle (WLTC) and corresponding test procedure (WLTP). The switch of test procedure will not only affect the effectiveness of technologies but also change the fuel consumption target of the industry. However, few studies have systematically investigated the impacts of the new WLTP on the Chinese market. This study establishes a “technology–vehicle–fleet” bottom–up framework to estimate the impacts of test procedure switching on technology effectiveness and regulation stringency. The results show that due to the WLTP being closer to the real driving condition and more stringent, almost all baseline vehicles in the WLTP have higher fuel consumption than that in the NEDC, and diesel vehicles are slightly more impacted than gasoline vehicles. In addition, the impacts are increased with the strengthening of electrification, where the fuel consumption of plug–in hybrid electric vehicles (PHEVs) and range-extended electric vehicles (REEVs) in the WLTP are about 6% higher than that in the NEDC. Engine technologies that gain higher effects in low load conditions, such as turbocharging and downsizing, fuel stratified injection (FSI), lean–burn, and variable valve timing (VVT), are faced with deterioration in the WLTP. Among these, the effect of turbocharging and downsizing shows a maximum decline of 8.5%. The variable compression ratio (VCR) and stoichiometric gasoline direct injection (SGDI) are among the few technologies that benefited from procedure switching, with an average improvement of 1.6% and 0.2% respectively. Except for multi–speed transmissions, which have improvement effects in the WLTP, all automatic transmissions are faced with decreases. From the perspective of the whole fleet and national regulation target, the average fuel consumption in the WLTP will increase by about 7.5% in 2025 compared to 4 L/100 km in the NEDC. According to the current planning of the Chinese government, the fuel consumption target of Phase V is set at 4.6 L/100 km in 2025, which is equivalent to loosening the stringency by 0.3 L/100 km. In Phase VI, the target of 3.2 L/100 km is maintained, which is 30.4% stricter than that of Phase V, and the annual compound tightening rate reaches 7.5%. This means that automakers need to launch their product planning as soon as possible and expand the technology bandwidth to comply with the Phase VI fuel consumption regulation, and the government should evaluate the technical feasibility before determining the evaluation methods and targets of the next phase.

Simulation and Experimental Comparison of Fuel Consumption for a Heavy-duty Diesel Vehicle

Experimental Study on Fuel Economy of Fuel Cell Truck Under Different Driving Cycle

Real World Fuel Consumption and Emissions Simulation and Its Application for Heavy Duty Diesel Vehicles

Research on test method for fuel consumption of heavy-duty commercial vehicles

Using a Chassis Dynamometer to Determine the Influencing Factors for the Emissions of Euro VI Vehicles

Research on Influence of Beijing-VI Diesel on Consumption and Emission Characteristics of Euro VI Diesel Bus

Assessment of Energy Consumption Characteristics of Ultra-Heavy-Duty Vehicles under Real Driving Conditions

Investigation of Heavy-Duty Vehicle Chassis Dynamometer Fuel Consumption and CO2 Emissions Based on a Binning-Reconstruction Model Using Real-Road Data

A Comparative Study of Different Hybrid Electric Powertrain Architectures for Heavy-Duty Truck

Fuel consumption and emission performance from light-duty conventional/hybrid-electric vehicles over different cycles and real driving tests

Adaptability of NTE and AWM Heavy-Duty Diesel Vehicles In-Use Compliance Test Methods to Typical Road Conditions in China

Impacts of the New Worldwide Light-Duty Test Procedure on Technology Effectiveness and China’s Passenger Vehicle Fuel Consumption Regulations

Research and Verification of Energy Consumption and E-range of Heavy-Duty Plug-in Hybrid Electric Vehicle

Numerical study on the performance, combustion characteristics and energy flow distribution of gasoline-powered vehicle under synthetic actual driving test cycle

Variability of fuel consumption and CO2 emissions of a gasoline passenger car under multiple in-laboratory and on-road testing conditions

Vehicle Simulation on the Test Bench

Real-world Fuel Consumption of Light-Duty Passenger Vehicles Using On-Board Diagnostic (OBD) Systems

Real-world Fuel Consumption and CO2 (carbon Dioxide) Emissions by Driving Conditions for Light-Duty Passenger Vehicles in China

Influence of Test Cycle and Fuel Property on Fuel Consumption and Exhaust Emissions of a Heavy-Duty Diesel Engine

Comparative Analysis of Real-World Emissions and IVE Prediction from a Heavy-Duty Diesel Bus Based on FEMS

Energy Consumption Simulation of Urban Bus Fueled with Dimethyl Ether