Abstract:A modified polymerizable complex (PC) method for the preparation of the relaxor ferroelectric 0.65Pb(Mg1/3Nb2/3)O-3-0.35PbTiO(3) (PMN-PT) ceramics has been developed using a novel water-soluble Nb precursor. The effects of Pb content and sintering temperature on the structure, morphology, composition, and electrical properties of PMN-PT powders and ceramics were investigated systematically. It was found that the modified PC method could effectively reduce the initial crystallization temperature of the perovskite phase to 500 degrees C. For PMN-PT samples with 15% excess Pb content sintered at 600 degrees C for 2 h, the 87% perovskite phase can be achieved, which is much higher than that in conventional solid-state reactions and other solution-based methods at the same temperature. On further increasing the sintering temperature to 1100 degrees C, the perovskite phase content basically remains constant. This is attributed to the Pb-deficient pyrochlore phase formation. On increasing the sintering temperature to 1250 degrees C, the dielectric constant and remnant polarization of PMN-PT ceramics significantly improved due to the larger grain sizes, enhanced density, and the decreasing pyrochlore phase. PMN-PT ceramics with a 98.5% content of the perovskite phase have been fabricated at 1250 degrees C. It displays typical ferroelectric relaxor characteristics with a remnant polarization of 18 mu C/cm(2), a coercive field of 9.6 kV/cm, a piezoelectric coefficient of d(33) = 360 pC/N, and room-temperature and maximum dielectric constants of 3600 and 10 500 at 1 kHz, respectively.

Sm and Mn doped enhancing the electrical properties of .68PMN–.32PT relaxor ferroelectric thin films

Ferroelectric-to-relaxor transition and ultrahigh electrostrictive effect in Sm3+-doped Pb(Mg1/3Nb2/3)O3-PbTiO3 ferroelectrics ceramics

Enhanced dielectric, ferroelectric, and optical properties in rare earth elements doped PMN-PT thin films

Enhanced Ferroelectric, Dielectric Properties of Fe-Doped PMN-PT Thin Films

Electromechanical properties of PMN-PT thin films prepared by pulsed laser deposition technique

Chemical composition-induced evolution of the structure, domain and electrical properties of Sm-doped (1 - x)Pb(Ni1/3Nb2/3)O3- x PbTiO3

Mn‐doped Pb(In1/2Nb1/2)O3‐Pb(Mg1/3Nb2/3)O3‐PbTiO3 relaxor ferroelectric ceramics for high‐power piezoelectric applications

Thermally Stable Capacitive Energy-Density and Colossal Electrocaloric and Pyroelectric Effects of Sm-Doped Pb(Mg 1/3 Nb 2/3 )O 3 -PbTiO 3 Thin Films

High‐quality ternary relaxor ferroelectric thin films on Si substrates by pulsed laser deposition method

Synthesis and Characterization of Pb(Mg1/3Nb2/3)O3–PbTiO3 Relaxor Ferroelectrics Modified by Ba(Mg1/3Nb2/3)O3

Improved piezoelectric properties of Pb(Mg1/3Nb2/3)O3-PbTiO3 textured ferroelectric ceramics via Sm-doping method

Investigations on electric properties and domain structures of Nd-doped 0.70Pb(Mg1/3Nb2/3)O 3 –0.30PbTiO 3 relaxor ferroelectric ceramics with high piezoelectric properties

Growth and electrical properties of high‐Curie point rhombohedral Mn‐Pb(In 1/2 Nb 1/2 )O 3 ‐Pb(Mg 1/3 Nb 2/3 )O 3 ‐PbTiO 3 thin films

Enhanced piezoelectric and optical properties of tetragonal Sm‐doped Pb(In1/2Nb1/2)‐Pb(Mg1/3Nb2/3)‐PbTiO3 crystals

Preparation and Characterization of Relaxor Ferroelectric 0.65pb (Mg1/3nb2/3)o-3-0.35pbtio(3) by A Polymerizable Complex Method

Enhanced electrostrains in PMN‐xPZN solid solutions driven by a rather small electric field

Improved dielectric and piezoelectric properties of Sm-doped Pb(Mg1/3Nb2/3)O3–Pb(Zn1/3Nb2/3)-PbTiO3 ternary ferroelectric ceramics

Sm2O3 and MnO2 codoped PMN-PZT ceramics with both high mechanical quality factor and piezoelectric properties

Effect of PMN Content on the Phase Structure and Electrical Properties of PMN–PZT Ceramics

Study on Dielectric-Properties of Pmn-Pzn-Pt Ferroelectric Relaxor Ceramics

Study of the Structure and Dielectric Relaxation Behavior of Pb(Mg1/3Nb2/3)O3–PbTiO3 Ferroelectric Ceramics