Deposition of Ultrathin MgB 2 Films from a Suspension Using Cosolvent Marangoni Flow

Thi Kieu Ngan Pham,Edward Bruffey,Anh Tuan Nguyen,Ricardo A. Rivera-Maldonado,Ding-Yuan Kuo,Brandi Cossairt,Woochul Lee,Godwin Severa,Joseph J. Brown
DOI: https://doi.org/10.1021/acs.langmuir.2c02933
IF: 3.9
2023-03-09
Langmuir
Abstract:Magnesium diboride (MgB<sub>2</sub>) has demonstrated, theoretically and experimentally, promise as a candidate material for hydrogen storage and has thus attracted much contemporary research interest. To study hydrogen gas adsorption on MgB<sub>2</sub> thin films using a quartz crystal microbalance (QCM)─a workhorse apparatus for this specific experiment─MgB<sub>2</sub> must be deposited uniformly on the active surface of the QCM without damaging the quartz's performance. In work presented here, a wet-chemistry colloid synthesis and deposition process of a MgB<sub>2</sub> thin film on a gold (Au) surface was established to avoid the extreme conditions of conventional physical deposition methods. This process also counteracts the unwanted phenomena of drying droplets on a solid surface, particularly the coffee-ring effect. To verify the normal function of the QCM after MgB<sub>2</sub> deposition and its ability to obtain meaningful data, simple gas adsorption tests were conducted on the QCM, and the MgB<sub>2</sub> film on the QCM was characterized with X-ray photoelectron spectroscopy (XPS) and atomic force microscopy (AFM) for elemental analysis and surface roughness, respectively. To obtain information about the thickness and the involvement of the coffee-ring effect, the same synthesis route was applied on a similar gold substrate─an evaporated Au film on glass. XPS characterization of the film and its precursor suspension shows the potential existence of both MgB<sub>2</sub> and its oxide forms. The film's thickness on evaporated Au was measured by scanning transmission electron microscopy (STEM) to be 3.9 nm. The resulting samples show mitigation of the coffee-ring effect through roughness measurements with AFM at two scan sizes of 50 × 50 and 1 × 1 μm<sup>2</sup>.
chemistry, multidisciplinary, physical,materials science
What problem does this paper attempt to address?