Abstract:In order to overcome the drag at hypersonic speed, hypersonic flight vehicles require a high level of integration between the airframe and the propulsion system. Propulsion system based on scramjet engine needs a close interaction between its aerodynamics and stability. Hypersonic vehicle nozzles which are responsible for generating most of the thrust generally are fused with the vehicle afterbody influencing the thrust efficiency and vehicle stability. Single expansion ramp nozzles (SERN) produce enough thrust necessary to hypersonic flight and are the subject of analysis of this work. Flow expansion within a nozzle is naturally 3D phenomena; however, the use of side walls controls the expansion approximating it to a 2D flow confined. An experimental study of nozzle performance traditionally uses the stagnation conditions and the area ratio of the diverging section of the tunnel for approaching the combustor exit conditions. In this work, a complete hypersonic vehicle based on scramjet propulsion is installed in the test section of a hypersonic shock tunnel. Therefore, the SERN inlet conditions are the real conditions from the combustor exit. The performance of a SERN is evaluated experimentally under real conditions obtained from the combustor exit. To quantify the SERN performance parameters such as thrust, axial thrust coefficient C f x and lift L are investigated and evaluated. The generated thrust was determined from both static and pitot pressure measurements considering the installation of side walls to approximate 2D flow. Measurements obtained by a rake show that the flow at the nozzle exit is not symmetric. Pitot and pressure measurements inside the combustion chamber show nonuniform flow condition as expected due to side wall compression and boundary layer. The total axial thrust for the nozzle obtained with the side wall is slightly higher than without it. Static pressure measurements at the centerline of the nozzle show that the residence time of the flow in the expansion section is short enough and the flow of the central region of the nozzle is not altered by the lateral expansion when nozzle configuration does not include side walls.

Numerical Study of Facility Pressure Effects on Micronozzles for Space Propulsion

Computational Study of Lateral Jet Interaction in Hypersonic Thermochemical Non-Equilibrium Flows Using Nonlinear Coupled Constitutive Relations

Fully kinetic study of facility pressure effects on RF-source magnetic nozzles

Micronozzle Flow Based on Simulation of Molecule Movement

Size Effect on Gas Flow in Micro Nozzles

Study on Micronozzle Flow and Propulsion Performance Using DSMC and Continuum Methods

GAS FLOW CHARACTERISTICS IN MICRO-NOZZLE

3-D Numerical Simulation of Gas Flow in Micronozzles

Background pressure effects on ion dynamics in a low-power magnetic nozzle thruster

Numerical Simulation and Experiments on Gas Flow in Micro-Nozzle

Effect of Temperature Boundary Conditions on Micronozzle Performance

Transient behavior of a supersonic three-dimensional micronozzle with an intersecting capillary

Sonic point position and critical pressure ratio in micro nozzles

Numerical Simulation on Effects of Flight Parameters on Internal Flow of Jet Vector Nozzle

Experimental Study of Single Expansion Ramp Nozzle Performance Using Pitot Pressure and Static Pressure Measurements

Three-Dimensional Kinetic Simulation of an Ion Thruster Plume with Carbon Backsputtering in a Vacuum Chamber

Effect of Slip Boundary Condition on Numerical Results of 2D Micro Thruster

Numerical and Experimental Investigation of the Influence of Backpressure on a Confined Impinging Jet for Small Nozzle-to-plate Spacing

Numerical Simulation on Micro Thruster Sub-Sonic Flow Field

Numerical Study on the Effect of Mass Flux on the Low Frequency Pressure Oscillation Occurred in Oxygen Jet Condensation

Investigation of thrust augmentation and nozzle exit pressure in starting jets from a tube nozzle