Abstract:Durability and start-up ability in sub-zero environment are two technical bottlenecks of vehicular polymer electrolyte membrane (PEM) fuel cell systems. With exhaust gas recirculation on the anode and cathode side, the cell voltage at low current density can be reduced, and the membrane can be humidified without external humidifier. They may be helpful to prolong the working lifetime and to promote the start-up ability. This paper presents an experimental study on a PEM fuel cell system with anodic and cathodic recirculation. The system is built up based on a 10 kW fuel cell stack, which consists of 50 cells and has an active area of 261 cm(2). A cathodic recirculation pump and a hydrogen recirculation pump are utilized on the cathode and anode side, respectively. Key parameters, e.g., stack current, stack voltage, cell voltage, air flow, relative humidity on the cathode side, oxygen concentration at the inlet and outlet of the cathode side, are measured. Results show that: 1) with a cathodic recirculation the system gets good self humidification effect, which is similar to that with an external humidifier; 2) with a cathodic recirculation and a reduction of fresh air flux, the cell voltage can be obviously reduced; 3) with an anodic recirculation the cell voltage can also be reduced due to a reduction in the hydrogen partial pressure, the relative humidity on the cathode side is a little smaller than the case with only cathode recirculation. It indicates that, for our stack the cathodic recirculation is effective to clamp cell voltage at low current density, and a self-humidification system is possible with cathodic recirculation. Further study will focus on the dynamic model and control of the dual recirculation fuel cell system. (C) 2017 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Performance analysis and dynamic characteristics of a proton exchange membrane fuel cell with dual recirculation pumps for air-free applications

Optimization strategies to mitigate reactant starvation in a dead-ended hydrogen–oxygen proton exchange membrane fuel cell during cyclic loading

Performance Evaluation and Degradation Mechanism for Proton Exchange Membrane Fuel Cell with Dual Exhaust Gas Recirculation

Performance enhancement in a H2/O2 PEMFC with dual-ejector recirculation

Droplet Dynamics in a Proton Exchange Membrane Fuel Cell with Ejector-Based Recirculation

Water management and performance enhancement in a proton exchange membrane fuel cell system using optimized gas recirculation devices

Analysis of the influence of cathode recirculation strategy on proton exchange membrane fuel cell from internal polarization and external characteristics perspectives

Experimental study of voltage uniformity and stability of H 2 /O 2 PEM fuel cell stack with dead-end anode and recirculation cathode

Experimental study on current density distribution characteristics in a novel oxygen recirculation system of dead-ended proton exchange membrane fuel cell

Effect of cathode recirculation on high potential limitation and self-humidification of hydrogen fuel cell system

Experimental investigation of operating characteristics of proton exchange membrane fuel cell with different anode strategies based on the segmented cell

Catalyst Degradation Mitigation and Fuel Utilization Enhancement of a Dead-Ended Anode and Cathode Proton Exchange Membrane Fuel Cell with Periodical Oxygen Supply

Experimental Study on Dual Recirculation of Polymer Electrolyte Membrane Fuel Cell

Experimental study on the dynamic response of voltage and temperature of an open-cathode air-cooled proton exchange membrane fuel cell

Study on Voltage Clamping and Self-Humidification Effects of Pem Fuel Cell System with Dual Recirculation Based on Orthogonal Test Method

Two-Dimensional simulation of purge processes for dead-ended H 2 /O 2 proton exchange membrane fuel cell

Dynamic performance for a kW-grade air-cooled proton exchange membrane fuel cell stack

Research Progress on Gas Supply System of Proton Exchange Membrane Fuel Cells

Comprehensive performance assessment and multi-objective optimization of high-power proton exchange membrane fuel cell system under variable load

Anode purge management for hydrogen utilization and stack durability improvement of PEM fuel cell systems

Optimal Design and Operation of Dual-Ejector PEMFC Hydrogen Supply and Circulation System