Development of Double-Insulated Ring Sensors for Hollow Pin Preload Measurement
Chenghui Feng,Jiang Zhu,Qianping Wang,Guangming Jiao,Wensheng Li,Quanshi Cheng,Chuan Wang,Binhong Xia,Yanghui Jiang,Jun Zhang,Bing Yang
DOI: https://doi.org/10.1109/jsen.2023.3244857
IF: 4.3
2023-04-05
IEEE Sensors Journal
Abstract:The hinge mechanism of aviation flap is composed of joint bearing, single lug, double lugs, hollow pins, self-locking nuts, and so on. This hinge mechanism has accurate requirements for the preload of the hollow pin. When no seizure of the joint bearing occurs, the bolts are required to have sufficient preload to clamp the inner ring of the bearing. Meanwhile, when the seizure of the joint bearing occurs, there shall be no movement between the bearing and pin shaft or the end face of the bushing shall arise. This requires that the tension of the hollow pin shaft shall not be too high; otherwise, the friction torque is not easy to overcome. However, the method to directly measure the preload in the hollow pin is not available, and the influence law of preload decline on the seizure resistance of the bearings also cannot be evaluated. This article presents a method suitable for measuring the preload of hollow thin-walled pin parts. By applying permanent piezoelectric thin-film transducer onto the end face of the hollow pin, the standardization technology is used to measure the propagation time change of the ultrasonic signal generated by the transducer in the pin as a function of the temperature and preload, thus realizing the accurate measurement for the preload of the hollow pin during installation. Finally, the application verification is conducted by using the measurement method proposed in this article. The results show that this method can effectively optimize the installation and service performance for the hollow pin.
engineering, electrical & electronic,instruments & instrumentation,physics, applied