Abstract:Carbon capture and storage (CCS) is gathering the momentum to achieve the ultimate target of carbon neutrality. Temperature vacuum swing adsorption (TVSA) has uncovered its superiority due to large working capacity, CO2 purity and recovery rate. However, high energy demand in the regeneration process of adsorbent leads to the loss of net efficiency of coal-fired power plant (CFPP) after retrofitted. This paper initially proposes and evaluates an integrated system which is composed of an adsorption carbon capture unit (ADCCU) and a single-effect absorption heat transformer (SAHT). Then a general concept of sorption carbon capture integrated with heat pump could be introduced. Results indicates that CO2 purity and recovery rate of the integrated system vary from 91.20 % to 92.75 % and from 95.62 % to 98.11 % when flowrate range from 48 NL center dot min(-1) to 60 NL center dot min(-1). Under the condition of 140 degrees C regeneration temperature of ADCCU and 80 degrees C generation temperature of SAHT, exergy efficiency of SAHT achieves the maximum value of 85.28 %. Moreover, a vapor compression heat pump (VCHP) system is coupled to provide moderate temperature heat for SAHT when waste heat of CFPP is inadequate. The effect of waste heat and electricity consumed on performance of CFPP is also taken into consideration. When recovery rate is lower than 27 %, performance of the proposed integrated system is more favorable than that using steam evacuated from the turbine. It is demonstrated that heat pump assisted adsorption capture for CFPP may be a promising solution to reduce energy consumption in the near future.

Sorbent-coated carbon fibers for direct air capture using electrically driven temperature swing adsorption

Moisture-swing sorption for carbon dioxide capture from ambient air: a thermodynamic analysis.

Temperature-vacuum Swing Adsorption for Direct Air Capture by Using Low-Grade Heat

Capturing Carbon Dioxide from Air with Charged-Sorbents

Kinetic Analysis of an Anion Exchange Absorbent for Co2 Capture from Ambient Air

Development of sorbent materials for direct air capture of CO2

Preparation and Kinetics of a Heterogeneous Sorbent for CO 2 Capture from the Atmosphere

A Comparative Study of Different Sorbents in the Context of Direct Air Capture (DAC): Evaluation of Key Performance Indicators and Comparisons

Thermodynamic Study on Two Adsorption Working Cycles for Direct Air Capture

A Moisture Swing Sorbent for Direct Air Capture of Carbon Dioxide: Thermodynamic and Kinetic Analysis

Analysis on Temperature Vacuum Swing Adsorption Integrated with Heat Pump for Efficient Carbon Capture

Supercapacitive Swing Adsorption for Direct Air Capture

Direct Air Capture Technology and Its Application

Techno-economic Analysis on Temperature Vacuum Swing Adsorption System Integrated with Pre-Dehumidification for Direct Air Capture

Integrated direct air capture and CO2 utilization of gas fertilizer based on moisture swing adsorption

Integrated Direct Air Capture and CO 2 Utilization of Gas Fertilizer Based on Moisture Swing Adsorption

Experimental study of CO2 capture from air via steam-assisted temperature-vacuum swing adsorption with a compact kg-scale pilot unit

Sorption direct air capture with CO2 utilization

Adsorption-based Post-Combustion Carbon Capture Assisted by Synergetic Heating and Cooling

Flue-Gas Carbon Capture on Carbonaceous Sorbents: Toward a Low-Cost Multifunctional Carbon Filter for “green” Energy Producers