Abstract:The microstructure evolution and selection of α variants in a new near β titanium alloy Ti-5321 (Ti–5Al–3Mo–3V–2Cr–2Zr–1Nb–1Fe) were thoroughly investigated by dilatometry under continuous cooling conditions accompanied with OM, XRD, SEM, EBSD and TEM. Cooling rates from β region to room temperature significantly influenced the microstructure based on the competitive growth of αGB, αWGB and αWI. The low (0.01 °C/s and 0.1 °C/s), intermediate (0.5 °C/s and 1 °C/s) and high (2 °C/s, 4 °C/s and 5 °C/s) cooling rates resulted in bi-lamellar, basket-weave and single metastable-β microstructures, respectively. Moreover, the transformed microtexture was also found in the cooling process at low cooling rate. In addition, a continuous cooling transformation (CCT) diagram obtained by the dilatometric analysis revealed the sensibility of the β→α phase transformation temperature range to the cooling rate. EBSD analysis revealed that microtexture formed by α colonies with the similar orientations, occurred in the adjacent β grains and maintained Burgers orientation relationship (OR) with at least one of the adjacent β grains. Two typical cases, i.e. the single-BOR α colonies (the colonies which maintain Burgers OR with β grain only on one side) and the double-BOR α colonies (α colonies which maintain Burgers OR with both the adjacent β grains) were studied. The single-BOR α colonies corresponded to the different α variants from the parent β grain. The double-BOR α colonies occurred in which the adjacent β grains shared nearly common {110}β plane, moreover, the double-BOR α colonies could possess the identical orientation in the adjacent β grains which have a 60° rotation about a common <111>β direction.

Quantitative characterization of lamellar α precipitation behavior of IMI834 Ti-alloy in isothermal and non-isothermal heat treatments

Atomic-scale study on the precipitation behavior of an Al-Zn-Mg-Cu alloy during isochronal aging

Effects of the cooling rate on mechanical properties and microstructure of near- α Ti-6Al-3Zr-2Nb-Mo alloy

Influence of cooling rate on the precipitation kinetics of nanoscale isothermal ω-phase in metastable β-Ti alloy, Ti–5Al–5Mo–5V–3Cr

The role of the ω phase on the microstructure evolution of precipitation and mechanical property in Ti-3Al-5Mo-4Cr-2Zr-1Fe

Analysis on phase transformation and lamellar formation of Ti-47.5Al-3Nb-1.5/3.5Cr alloys by confocal laser scanning in-situ observation

Effect of deformation and cooling on non-equilibrium microstructure evolution and phase-transition mechanism of Ti–6Al-2.5Mo-1.5Cr-0.5Fe-0.3Si

The investigation of precipitation behavior of titanium compounds for high titanium steel based on in situ observation

In-situ investigation of β/α transformation in β-solidifying γ-TiAl alloys at different cooling rates

Effects of cooling rates on precipitates in homogenized Al–Cu–Li alloy

In-situ observation microstructure evolution and growth kinetics of lamellar γ phases in Ti44Al alloy during heat treatment

Effects of cooling manner on Laves phase precipitation and mechanical properties of Al modified super ferritic stainless steels

Quantitative analysis on microstructure characteristic of pre-strained β-solidified TiAl alloy during post-heat treatment

Investigation on the microstructure evolution and dynamic recrystallization mechanisms of TiAl alloy at elevated temperature

Orderly Nucleation and Competitive Growth Behaviors of Ti-Al Intermetallic Compounds in Ti/TiAl3 Diffusion Couple under High Temperature

MICROSTRUCTURE, MECHANICAL PROPERTIES AND INTERPHASE PRECIPITATION BEHAVIORS IN V-Ti MICROALLOYED STEEL

The Effect of Cooling Rate on Microstructure and Mechanical Properties of the Zr-4Hf-3Nb (wt%) Alloy

TEM characterization of the precipitation reaction in Ti–48Al–10Nb alloy

Insight into the recrystallization behavior and precipitation reaction of in-situ nano TiB2/Al Cu Mg composite during heat treatment

Precipitation behavior of an Al–Cu–Li–X alloy and competing relationships among precipitates at different aging temperatures

Effect of cooling rate on α variant selection and microstructure evolution in a near β Ti–5Al–3Mo–3V–2Cr–2Zr–1Nb–1Fe alloy