Abstract:Applying stress/strain on a material provides a mechanism to tune the thermal conductivity of materials dynamically or on demand. Experimental and simulation results have shown that thermal conductivity of bulk materials can change significantly under external pressure (compressive stress). However, stress/strain effects on the thermal conductivity of nanostructures have not been systematically studied. In this paper, equilibrium molecular-dynamics (EMD) simulation is performed to systematically study the strain effects on the lattice thermal conductivity of low-dimensional silicon and carbon materials: silicon nanowires (one dimensional) and thin-films (two dimensional), single-walled carbon nanotube (SWCNT, one dimensional) and single-layer graphene sheet (two dimensional). Spectral analysis of EMD is further developed and then applied to avoid the numerical artifacts such as the neglect of long-wavelength phonons that are often encountered when using EMD with periodic boundary conditions. Intrinsic thermal conductivity of the simulated bulk and nanostructures can be obtained using spectral analysis of EMD. The thermal conductivity of the strained silicon and diamond nanowires and thin films is shown to decrease continuously when the strain changes from compressive to tensile. However, for SWCNT and single-layer graphene, the thermal conductivity has a peak value, and the corresponding applied strain is at -0.06 or -0.03 for SWCNTs depending on the chirality and at zero for graphene, respectively. The following two reasons could explain well the effects of strains on the thermal conductivity of the nanowires and thin films that decreases continuously from compressive strain to tensile strain: (1) mode-specific group velocities of phonons decrease continuously from compressive strain to tensile strain and (2) the specific heat of each propagating phonon modes decrease continuously from compressive strain to tensile strain. However, for SWCNT and single-layer graphene, the mechanical instability induces buckling phenomenon when they are under compressive strains. The phonon-phonon scattering rate increases significantly when the structure buckles. This results in the decreasing behavior of thermal conductivity of SWCNT and graphene under compressive stress and explains the peak thermal conductivity value observed in SWCNT and single-layer graphene when they are under strain. The results obtained in this paper has important implications of challenging thermal management of electronics using advanced materials such as carbon nanotubes and graphene. It also points to a potentially new direction of dynamic thermal management.

Tensile strains give rise to strong size effects for thermal conductivities of silicene, germanene and stanene

Unexpectedly Large Tunability of Lattice Thermal Conductivity of Monolayer Silicene via Mechanical Strain

Anomalous strain effect on the thermal conductivity of low-buckled two-dimensional silicene

Phonon Transport Properties of Two-Dimensional Group-Iv Materials from Ab Initio Calculations

Tuning The Thermal Conductivity Of Silicene With Tensile Strain And Isotopic Doping: A Molecular Dynamics Study

Effects of tensile strain and finite size on thermal conductivity in monolayer WSe 2 .

Tensile Strain Induced Enhancement of Lattice Thermal Conductivity and Its Origin in Two-Dimensional SnC

Strain effects on phonon transport in antimonene from a first-principles study

Phonon Properties, Thermal Expansion, And Thermomechanics Of Silicene And Germanene

Strain Effects On The Thermal Conductivity Of Nanostructures

Tuning Thermal Conductivity with Mechanical Strain

First-Principles Study of the Stability of Silicane and Germanane under Strain

Tensile strain and finite size modulation of low lattice thermal conductivity in monolayer TMDCs (HfSe2 and ZrS2) from first-principles: a comparative study

Effects of Temperature and Strain Rate on the Mechanical Properties of Silicene

Tunable Electronic and Optical Properties of Monolayer Silicane under Tensile Strain: a Many-Body Study.

Tuning the Electronic Structure of Silicene and Germanene by Biaxial Strain and Electric Field

Phonon-mediated Superconductivity in Silicene

Equibiaxial Strain Regulates the Electronic Structure and Mechanical, Piezoelectric, and Thermal Transport Properties of the 2H-Phase Monolayers CrX2 (X = S, Se, Te).

Phonon-mediated Superconductivity in Silicene Predicted by First-Principles Density Functional Calculations

Equibiaxial strain regulates the electronic structure, mechanical properties, piezoelectric, and thermal transport properties of the 2H-phase monolayer CrX2 (X=S, Se, Te)

Flexural and acoustic phonon-drag thermopower and electron energy loss rate in silicene