Abstract:The ±1100 kV UHVDC wall bushing is the important power equipment in the ±1100 kV DC power transmission project of China. However, the reported literatures rarely mention its design method and the optimization of its insulation structure. In this paper, two specific designing schemes including the resin impregnated paper (RIP) condenser and the metal-shielded core have been both adopted in the design of the wall bushing. Moreover, the actual operating environment and the rated parameters of the ±1100 kV UHVDC wall bushing have been analyzed in detail. Then, the nonlinear finite element method (FEM) analysis has been applied in the three-dimensional electric stress simulation of the UHVDC wall bushing. The electric field and temperature dependencies of the composite insulation used in the wall bushing have been taken into account. The E-field simulation results indicate that with the RIP condenser, the potential and electric field distribution can be much more uniform along the composite insulator of the bushing. Therefore, the compact design of the wall bushing can be obtained by this designing scheme. On the other hand, with the type of the metal-shielded core, the high E-field strength areas are mainly concentrated on the metal shield and the outer grading ring of the wall bushing. Therefore, the nonlinear FEM was applied in the structure optimization of the internal metal-shielded system used in the wall bushing. Finally, the maximum E-field strength of the wall bushing can meet the control requirement. Based on the simulation results and the optimization structure, the ±660 kV scaled prototype of the UHVDC wall bushing has been produced and passed through all the type tests according to the IEC 62199. The feasibility of the design of the ±1100 kV UHVDC wall bushing has been verified. This paper can provide the theoretical guidelines for the design, manufacture and operation of the UHVDC wall bushing.

On the design, testing and operating experience of composite dry bushings in HVDC

Analysis and Prevention Treatment for Rain Flashover Accident of ±500 Kv Composite Bushing

Advances in HVdc Bushing Using Nonlinear Materials: Theory, Materials, Structure, and Realization

Pollution Flashover Performances of SF6 Insulated DC Wall Bushing

Research on the Overheating Fault of HVDC Wall Bushing and Its Dignosis Strategies Based on CFD

Dielectric Characteristics of the ±1100kV UHVDC Wall Bushing with SF6 Gas Insulation

Design and dielectric characteristics of the ??1100 kV UHVDC wall bushing in china

Research on the Electrical Performance Design Criteria of the Adaptive Bushing Based on Nonlinear Materials

The Inner Voltage Component Analysis and Testing System for Converter Transformer Valve Side Bushings

Analysis and Disposal of Typical Breakdown Failure for Resin Impregnated Paper Bushing in the Valve Side of HVDC Converter Transformer

Investigation on distribution of electro-thermal coupled field and improved design of 1100 kV converter valve-side bushing

Impact of Temperature on the Transient DC Field Distribution of ±1100 kV UHVDC Wall Bushing

Rain Flashover Analysis of HVDC Reactor Bushing Using Rainwater-Air Mixture Model

Research on Profiles of HVDC Post Insulator and Bushing

Research on the dynamic characteristics of electric field distribution of the ± 1100 kV Ultra high voltage converter transformer valve‐side bushing using weakly ionised gas conductance model

Flashover Performance of Silicon Rubber under Combined AC-DC Voltage and Its Improving Method

Electro-thermal comprehensive analysis method for defective bushings in HVDC converter transformer valve-side under multiple-frequency voltage and current harmonics

Structure Design of UHVDC Pure SF6 Insulated Bushing

Optimization of Clearance Test Area for ± 1100 kV UHVDC Wall Bushing in AC and DC Partial Discharge Measurement

Heat Dissipation Improvement and Experimental Verification of Converter Transformer Valve Side Bushing Based on Water Cooling Technology

Analysis Of The Insulation Structure And Electrical Distribution Of 1100-Kv Oip Condenser Transformer Bushings In China