Abstract:The preparation process and method of powders and composite materials. As an emerging field of current technological development, the heat dissipation performance of electronic packaging materials has become the key to determining product reliability. Therefore, the applied thermal interface materials (TIMs) need to simultaneously meet the performance indicators of thermal conductivity, mechanics, and insulation. Although BN had excellent in‐plane thermal conductivity and insulation performance, it is currently difficult to achieve vertical orientation of powder which leads the layered powder cannot complete a continuous and effective heat transfer path along the Z‐axis direction inside the composite material. In order to solve the above two problems, out‐of‐plane thermal conductive composite was prepared by introducing magnetic oriented method. In order to comprehensively evaluate the thermal conductivity, mechanical and electrical properties, BN@Fe3O4/EP magnetic oriented composites were compared with BN@PDA‐Al2O3/EP composite prepared by mechanical blending method. The vertical thermal conductivity of the magnetic oriented composite material was 2.24 W/(m·K) at 30 vol%, which was 3.39 times that of the blended composite material and 12.4 times that of pure EP. This proves that the magnetic oriented composite materials prepared by the research institute can meet the vertical heat transfer needs in the field of electronic packaging and have high research value in this area. Highlights BN@Fe3O4 core–shell particles were prepared with both thermal conductivity and magnetic controllability. The thermosetting composites were prepared by heated through preliminary gel point and then cured at high temperature. The orientation of powder inside the matrix was constructed, resulted in excellent out‐of‐plane heat transfer performance. Comparisons were made between various properties of magnetic oriented materials and conventional blend materials. The magnetic orientation method is feasible in the field of electronic packaging.

On thermal characterization method of integrated magnetic components

Temperature Dependence of the Off‐diagonal Magnetoimpedance in Sensor Configuration Utilizing Co‐rich Amorphous Wires

Automated tool for 3D planar magnetic temperature modelling: application to EE and E/PLT core‐based components

An Investigation of Temperature Effects with On-Chip Passive Components

Magnetic thermal properties of CFRP and the mapping of magnetic field distribution to temperature field

An Inductive Method for Comprehensive Estimation of Temperature-Dependent Electrical and Thermal Properties of Conductive Ferromagnetic Materials

Thermal Annealing Impact on the Sensitivity of Piezomagnetic Surface Acoustic Waveguide to Applied Magnetic Field

Numerical investigation of the thermal convective phenomenon around a circular micro-coil with variable internal width

Thermal simulation and optimization of a Curie-based thermomagnetic motor harnessing concentrated solar energy

Methods for temperature estimation and monitoring of permanent magnet: a technology review and future trends

A Temperature Imaging Method for Multi-Chip High Power LEDs Based on the Magnetic Nanoparticle Thermometer

Analysis of experimental conditions for simultaneous measurements of transport and magnetotransport coefficients of high temperature superconductors

New sensor for thermodynamic measurement of magnetization reversal in magnetic nanomaterials

Experimental investigation on thermal conductivity and specific heat capacity of magnetic microencapsulated phase change material suspension

Analysis and experimental research on high frequency magnetic properties of different magnetostrictive materials under variable temperature conditions

The preparation and feasibility analysis of magnetic orientation method in the study of thermal insulation composite materials in the field of electronic packaging

Soft magnetic materials for sensor applications in the high frequency range

Thermal properties analysis of MEMS sensors by micro-grid method

On the scale effect of magnetic induction heating for microstructure

Elevated temperature initial permeability study of some ferromagnetic alloys

A Comparative Analysis of Printed Circuit Boards with Surface-Mounted and Embedded Components under Natural and Forced Convection