Efficient and Bright Deep‐red Light‐emitting Diodes Based on a Lateral 0D/3D perovskite Heterostructure
You Ke,Jingshu Guo,Decheng Kong,Jingmin Wang,Gunnar Kusch,Chen Lin,Dawei Liu,Zhiyuan Kuang,Dongmin Qian,Fuyi Zhou,Guangbin Zhang,Meiling Niu,Yu Cao,Rachel A. Oliver,Daoxin Dai,Yizheng Jin,Nana Wang,Wei Huang,Jianpu Wang
DOI: https://doi.org/10.1002/adma.202207301
IF: 29.4
2022-12-18
Advanced Materials
Abstract:Bright and efficient deep‐red light‐emitting diodes (LEDs) are important for applications in medical therapy and biological imaging due to the high penetration of deep‐red photons into human tissues. Metal‐halide perovskites have potential to achieve bright and efficient electroluminescence due to their favorable optoelectronic properties. However, efficient and bright perovskite‐based deep‐red LEDs have not been achieved yet, due to either Auger recombination in low‐dimensional perovskites or trap‐assisted nonradiative recombination in three‐dimensional perovskites. Here, we demonstrate a lateral Cs4PbI6/FAxCs1‐xPbI3 (zero‐dimensional/three‐dimensional, 0D/3D) heterostructure, which can enable efficient deep‐red perovskite LEDs at very high brightness. The Cs4PbI6 can facilitate the growth of low‐defect FAxCs1‐xPbI3, and act as low‐refractive‐index grids, which can simultaneously reduce nonradiative recombination and enhance light extraction. Our device reaches a peak external quantum efficiency of 21.0% at a photon flux of 1.75 × 1021 m−2 s−1, which is almost two orders of magnitude higher than that of reported high efficiency deep‐red perovskite LEDs. Our LEDs are suitable for pulse oximeters, showing an error <2% of blood oxygen saturation compared with commercial oximeters. This article is protected by copyright. All rights reserved
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology