Abstract:To improve the quality and efficiency of Z -directional 3D preform forming, the Z -yarn frictional force distribution model of the preform and its wear mechanism were investigated. In this study, a tensile force measuring device was designed to measure the force required to replace the guide sleeve, which is equivalent to the Z -yarn frictional forces. The frictional force is proportional to the number of preform layers and is applied to the preform decreased from the corner, edge, sub-edge, and middle in order. A back propagation neural network model was established to predict the friction at different positions of the preform with different layers, and the error was within 1.9%. The wear of Z -yarn was studied at different frictional positions and after different times of successive implantation into the preform. The results showed that with an increase in the number of Z -yarn implantations and frictional forces, the amount of carbon fiber bundle hairiness gradually increased, and the tensile fracture strength damage of the fiber was increasingly affected by the frictional forces. In the corner position of the preform, when the number of implantations was 25, the fiber fracture strength decreased non-linearly and substantially; in order to avoid fiber fracturing in the implantation process, the Z -yarn needs to be replaced in time after 20–25 cycles of continuous implantation. This study solves the problem of difficulty in measuring the force required for individual replacements owing to the excessive number of guide sleeves, puts forward the relationship between fiber wear, preform position, and implantation times, solves the phenomenon of fracture in the preform during Z -direction fiber implantation, and realizes the continuous implantation of fibers.

Design of Z-fiber Guiding Needle for Composite Material Preform with Large-Thickness and High-Density

A Novel Method for Through-Thickness Reinforcement of Laminated Composites Using Discrete Micro-Polarization-induced Fiber Injection (DMFI) Approach

A Mechanistic Predictive Model for Ultrasound Guided Insertion Process of Ø 0.11 Mm Z-pins

Design and analysis of the mandrel structure for a composite S-shaped inlet

Cutting Force Of Hollow Needle Insertion In Soft Tissue

Study on the Distribution of Frictional Forces on Z-yarn Continuous Implanted Preforms and Their Applications

Design and fabrication of carbon fibers with needle-like nano-HA coating to reinforce granular nano-HA composites

Architectural Engineering Inspired Method of Preparing C-f/ZrC-SiC with Graceful Mechanical Responses

Enhanced Interfacial Strength of Carbon Fiber/peek Composites Using a Facile Approach Via PEI&ZIF-67 Synergistic Modification

A novel printing strategy to fabricate polyetheretherketone (PEEK)-based composites via hollow filaments filled with multiple reinforcements

Investigation on insertion mechanism of ultrasound guided insertion process based on numerical simulation

Mechanical model of needle-punched (NP) carbon/carbon (C/C) composites with isogeometric beams-extended springs at mesoscale

A Novel Combining Method for Composite Groove Structure Fabrication

Process Design of Variable Fiber Content in Layers of Needle-Punched Preforms

Design of thorn-like micro/nanofibers: Fabrication and controlled morphology for engineered composite materials applications

Research on effects of braiding process on the composite preform quality using finite element method

Material Evaluation and Dynamic Powder Deposition Modeling of PEEK/CF Composite for Laser Powder Bed Fusion Process

Preparation of short CF/GF reinforced PEEK composite filaments and their comprehensive properties evaluation for FDM-3D printing

A new simulation method for characterizing the shear behavior of needled carbon fiber composites

Highly loaded carbon fiber filaments for 3D‐printed composites

Fabrication of Hydrogel-Based Composite Fibers and Computer Simulation of the Filler Dynamics in the Composite Flow