Abstract:Introduction Three‐dimensional (3D)‐printing technology can provide customizable simulations, but its effects on patient care quality have not been well studied. This study aimed to assess the impact of practicing with patient‐specific 3D‐printed teeth models on the quality of patients' dental preparations performed by students transitioning to clinical training. Accordingly, the quality of posterior crown preparations was evaluated by objectively analyzing digital scans and grades in two groups: the study group, which practiced beforehand with patient‐specific 3D‐printed teeth models, and the control group, which did not practice with these models. Methods All 78 fourth‐year dental students who had just finished their fixed prosthodontics course at the simulation laboratory with training on phantom heads and without previous clinical experience in crown preparations were invited to participate in the study. Sixty‐eight agreed to take part and were randomly divided into a study group that practiced crown preparations on 3D‐printed models of their own patient's teeth and a control group that did not practice with 3D‐printed models and started their clinical work straightforwardly after simulation training. Students completed validated perception questionnaires on self‐confidence and clinical skills before and after the protocol, which were compared using a chi‐squared test. Crown preparations performed on 3D‐printed models and then on patients were digitally scanned and objectively graded by prepCheck software for critical parameters, such as undercuts, taper, and occlusion reduction. Non‐parametric tests were used to compare preparations on 3D‐printed models and on patients performed by the study group and those on patients made by the control group. Results Initially, both groups reported similar perceptions of self‐confidence and clinical skills levels. The study group significantly improved both aspects after the protocol. Analysis of the scanned preparations demonstrated that the study group removed less tooth structure from actual patients than from the initial 3D‐printed models. In contrast, the control group showed excess occlusal clearance in their patients compared to the study group. Conclusions Practicing patient‐specific 3D‐printed teeth before performing procedures clinically appears to enhance preparation quality and minimize unnecessary tooth reduction in early clinical experiences.

Development of a three‐dimensional printed model from a digital impression of a real patient for aesthetic dentistry undergraduate teaching

Implementation of Patient-Individualized 3D-Printed Models in Undergraduate Students' Education for Various Prosthetic Treatments: A Cross-Sectional Survey Study

Development and evaluation of an interdisciplinary teaching model via 3D printing

Evaluation of a new 3D-printed tooth model allowing preoperative ICDAS assessment and caries removal

New scenarios for training in oral radiology: clinical performance and predoctoral students' perception of 3D-printed mannequins

Evaluation of Dental Students' Skills Acquisition in Endodontics Using a 3D Printed Tooth Model

Advanced digital planning approach using a 3D-printed mock-up. A case report

Comparison of digitally assessed quality of posterior crown preparations performed with and without previous practice on patient‐specific three‐dimensional‐printed teeth models

Preclinical motor chunking and fine motor skill learning in fixed prosthodontics: Contribution of 3D printing and satisfaction of dental students

3D printed replicas for endodontic education

Esthetic rehabilitation through crown lengthening and laminate veneers.

[Application of Three-Dimensional Digital Simulated Design and Implementation in Esthetic Rehabilitation].

Three Dimensional-Printed Gingivectomy and Tooth Reduction Guides Prior Ceramic Restorations: A Case Report

Application of 3D-Printed Plastic Teeth in the Teaching of Dental Morphology

Design and Validation of a 3D Printed Cranio-Facial Simulator: A Novel Tool for Surgical Education

Perceptions regarding the use of a three‐dimensionally‐printed manufactured educational simulator for periodontal treatment of intraosseous and interradicular lesions

3D printed teeth with adhesive bridge preparation guide

Application of 3D-printed plastic teeth in the teaching of tooth morphology

Three-dimensional printed apical barrier model technology for pre-clinical dental education

3D Digitization and Prototyping of the Skull for Practical Use in the Teaching of Human Anatomy

An Evaluation of the Accuracy of Digital Models-An In Vitro Study