Abstract:The behaviour of a pilot scale biological phosphorus removal process (BPR) of the alternating type was investigated during periods of low influent concentrations and increased hydraulic load. A process disturbance of this type result in an increase in the phosphate concentration level in the anoxic/aerobic reactors and in the plant effluent shortly after the influent wastewater returns to normal strength. The accumulation of phosphorus in the system was avoided by the addition of an external carbon source either to the influent or to the effluent from the anaerobic reactor in form of sodium acetate. With the help of such an addition, the internal carbon storage compounds could be maintained at a high level, which is shown by poly-hydroxy-alcanoates (PHA) measurements. Several levels of acetate addition were investigated experimentally in order to determine a minimal amount of internally stored carbon, which could ensure the stabilization of BPR during such dynamic influent conditions. Furthermore reduction of aeration time during periods of low influent concentrations was investigated. It was observed that BPR was stabilized by combining a reduction of aeration time with carbon source addition, which maintained the internal stored carbon at a higher level. This combined control action resulted in a desired high BPR activity when the normal strength of the influent wastewater was re-established. The failure of the BPR process was sometimes observed even when comparatively high concentrations of PHA could be detected and an identification of a minimal PHA level was not possible. During this investigation an extended version of the activated sludge model No. 2 (ASM2), which includes denitrification by phosphate accumulating organisms, is used for the detailed analysis of the experiments. The model predicted the phosphorus build-up after the process disturbance as well as the performance during the stabilized experiments. Assisted by the model, the investigations indicate that a PHA limitation is not the only factor affecting the recovery of the BPR process during periods of low influent concentrations.

Comparison of phosphorus removal characteristics between various biological nutrient removal processes

Comparison Study on Phosphorus Removal Between Single-stage Oxic Process and Anaerobic/Aerobic Process

Biological Phosphorus Removal Performance and Relevant Microorganism Characteristics of Activated Sludge in Municipal Wastewater Treatment Plants, China

Biological Nutrient Removal in A Sequencing Batch Reactor Operated As Oxic/Anoxic/Extended-Idle Regime

Experimental Research on Removal of Nitrogen and Phosphorus in Enhanced Sequencing Batch Reactor Activated Sludge Process

Analysis of Nitrogen and Phosphorus Removal in A~2O and Inverted A~2O Processes in a Wastewater Treatment Plant

Roles of nitrate recycling ratio in the A2/O - MBBR denitrifying phosphorus removal system for high-efficient wastewater treatment: Performance comparison, nutrient mechanism and potential evaluation

Variation of Phosphorus and Nitrogen Removal Characteristics According to the Decrease of Influent Phosphorus Concentration in SBR and SBBR

Comparison of Effects on Partial Nitrification Between Anoxic-Oxic and Controling DO/HRT Process

Comparison of Conventional and Inverted A(2)/O Processes: Phosphorus Release and Uptake Behaviors

Phosphorus removal characteristics of granular and flocculent sludge in SBR

A Comparative Study of the Bacterial Community in Denitrifying and Traditional Enhanced Biological Phosphorus Removal Processes.

Characteristics of nitrogen and phosphorus removal in SBR and SBBR with different ammonium loading rates

Enhanced nutrients removal from municipal wastewater through biological phosphorus removal followed by partial nitritation/anammox

Nitrogen and Phosphorus Removal Characteristics in Combined Short Aerobic SRT A2/O and BAF Process

Comparison of Nitrogen Removal Efficiencies and Microbial Communities of Full-Scale Anaerobic, Anoxic and Aerobic Processes in Municipal Wastewater Treatment Plants having Low and High COD/TN Ratios

Effect of Operating Parameters on Anoxic Biological Phosphorus Removal in Anaerobic Anoxic Sequencing Batch Reactor

BIOLOGICAL PHOSPHORUS REMOVAL BY A COMBINATION OF ANAEROBIC PHASE AND MBR

Experimental and model assisted investigation of an operational strategy for the BPR under low influent concentrations

Analysis on running effect for biological nitrogen and phosphorus removal of A/A/O technology

Microbial kinetic analysis of three different types of EBNR process