Dynamic Analysis of Trochoidal-Type Machine

Shuangqing Li,John B. Shung
DOI: https://doi.org/10.1115/96-detc/dac-1468
1996-08-18
Abstract:Abstract In a trochoidal-type machine, when the apex seals are replaced by tight running clearances between the rotor and chamber, the friction and wear can be eliminated and thus high efficiency and reliability can be obtained. There are many factors which contribute to the dynamic running clearances. The control of the vibration of the rotor-shaft system is important for the control of the running clearance. This paper studied the dynamics of the rotor-shaft system of a trochoidal-type machine without apex seal. The shaft is lumped as an equivalent system of a mass and a spring. The stiffness of the spring is determined by static equivalence of the two systems. In other words, when the same load is applied, the two systems should have the same displacement. The lumped mass is determined by the dynamic equivalence of the two systems. In other words, the natural frequency of the continuous system with expected mode is equal to the natural frequency of the lumped system. The bearings are modeled as distributed springs and dampers. The coefficients of the springs and dampers are obtained by solving the Reynolds’ equation. The established model can be used to predict the effect of the dynamics of the rotor-shaft system on the running clearances between the rotor and chamber.
What problem does this paper attempt to address?