Continued development of a joint-type knee wear simulator

J. D. Merwe

2012-03-01

Abstract:Continued Development of a Joint-Type Knee Wear Simulator J. van der Merwe Department of Mechanical and Mechatronic Engineering, University of Stellenbosch, Private Bag X1, Matieland 7602, South Africa. Thesis: MScEng (Mechatronic) March 2012 This thesis is concerned with the continued development of the Stellenbosch University joint-type knee wear simulator. Initially, information regarding simulators from the literature and commercial entities was collected to provide a knowledge base for current and future work. To further the design of the simulator itself, electronic hardware and software subsystems was developed and evaluated during experimental testing procedures. National Instruments’ cDAQ 9174 data acquisition unit was deemed inadequate for real-time inputoutput control, though proved sufficient for signal capturing purposes in conjunction with LabView software. Furthermore, the various servo-pneumatic sub-circuits’ individual ability to conform to the ISO 14243 series standards’ protocol led to the estimation of measurable performance criteria and the application to a single circuit for illustration. The anterior/posterior actuation circuit in question demonstrated adequate performance for the cases where the piston’s rod was respectively fixed and free to move. In-silico modelling and identification of the relevant servo-pneumatic components then commenced, with the valve and cylinder chamber models yielding adequate estimates of the recorded data. The identified quasi-static friction model proved sensitive to transient effects present within the system, resulting in performance deterioration of the integrated model. Sufficiently accounting for these effects would result in the emergence of the sub-circuit’s model as an invaluable tool in terms of control system development, prediction of the simulator’s behaviour and subsequent design recommendations. Future work therefore concerns improvement, identification and integration of the various sub-circuit models to fully exploit the aforementioned advantages. ii Stellenbosch University http://scholar.sun.ac.za

Engineering