Abstract:This study investigates an approach to temperature sensing by integrating Titanium Aluminum Nitride (TiAlN), originally engineered for wear and corrosion applications, as a temperature sensor within a multilayered thin film system. A nitride multilayer system was developed by physical vapor deposition (PVD) using a single four-target magnetron sputtering chamber; intermediate vacuum interruption steps were employed for masking procedures. The multilayer architecture design aimed to provide the sensor layer with mechanical protection and electrical shielding. Structural and electrical characterization of the TiAlN single layer revealed semiconductor behavior and stable electrical resistance up to 750 °C, with minimal signal stabilization requirements. Despite the higher Al content, the TiAlN temperature sensor exhibited a cubic crystal structure characterized by diffuse nanolayers resulting from a two-fold rotational deposition and target configuration. Detailed examination of the multilayer system cross-section, containing the TiAlN sensor, was conducted by scanning transmission electron microscopy (STEM). The analysis revealed its columnar morphology with the presence of typical PVD growth defects, including voids and droplets. While the presence of these defects may impact the electrical characteristics of the sensor, the selected experimental conditions effectively maintained the structural integrity of the multilayer system, despite the vacuum interruptions caused by masking procedures. Validation experiments confirmed the functionality of the multilayer system for temperature measurements up to 400 °C. The signal acquisition system addressed room temperature resistance variations and low sensitivity (thermistor coefficient ∼100 K), resulting in a measured error of approximately 6%. This study demonstrates promising results of TiAlN as a temperature sensor within a multilayered system, expanding its range of potential applications.

Niobium Nitride Thin Films for Very Low Temperature Resistive Thermometry

Nanowire Thermometers.

NTC thermo-sensitive ceramics with low B value and high resistance at low temperature in Li-doped Mn0.6Ni0.9Co1.5O4 system

Temperature-sensing array using the metal-to-insulator transition of NdxSm1−xNiO3

Experimental set-up for thermal measurements at the nanoscale using an SThM probe with niobium nitride thermometer

Molybdenum low resistance thin film resistors for cryogenic devices

Experimental setup for thermal measurements at the nanoscale using a SThM probe with niobium nitride thermometer

Can ZrAlN thin films be used as thermistor sensors for temperature assessment?

Ultrathin Transparent Nickel Electrodes for Thermoelectric Applications

Tunable Emission Color and Anti-Thermal-quenching Behaviors in Niobates for High-Sensitive Optical Thermometry

Nb 5 N 6 Thin Film on Silicon and Silicon Oxide: A Good Material for Terahertz Detection

Thermal Characterization of Low-Dimensional Materials by Resistance Thermometers

Nanomechanical thermometry for probing sub-nW thermal transport

A Thermal Airflow Sensor Based on Mn-Co-Ni-O Thin Film

Superconducting properties of very high quality NbN thin films grown by high temperature chemical vapor deposition

Expanding the applications of the wear-resistant titanium aluminum nitride thin-film to include temperature sensing

Investigation of the Positive Temperature Coefficient Resistivity of Nb-Doped Ba0.55Sr0.45TiO3 Ceramics

Cryogenic NbTiN Thin Film Resistors Fabricated by Using Reactive Magnetron Sputtering

Ion-beam Assisted Sputtering of Titanium Nitride Thin Films

Low temperature aluminum nitride thin films for sensory applications

Mechanical and Thermophysical Properties of Silicon Nitride Thin Films at High Temperatures Using In-Situ Mems Temperature Sensors