Abstract:This work extends the micro-thermal-bridge method for thermal conductivity measurements of nanowires to high temperatures. The thermal-bridge method, based on a microfabricated device with two side-by-side suspended membranes with integrated platinum resistance heaters/thermometers, has been used to determine thermal conductivity of various nanowires/nanotubes/nanoribbons at relatively low temperatures. However, to date, thermal conductivity characterization of nanowires at temperatures above 600 K has seldom been reported presumably due to several technical difficulties including the instability of the microfabricated thermometers, radiation heat loss, and the effect of the background conductance on the measurement. Here we report on our attempt to address the aforementioned challenges and demonstrate thermal conductivity measurement of boron nanoribbons up to 740 K. To eliminate high temperature resistance instability, the device is first annealed at 1023 K for 5 min in an argon atmosphere. Two radiation shields are installed in the measurement chamber to minimize radiation heat loss from the measurement device to the surroundings; and the temperature of the device at each set point is calibrated by an additional thermocouple directly mounted on the chip carrier. The effect of the background conductance is eliminated by adopting a differential measurement scheme. With all these modifications, we successfully measured the thermal conductivity of boron nanoribbons over a wide temperature range from 27 K to 740 K. The measured thermal conductivity increases monotonically with temperature and reaches a plateau of ~2.5 W m−1 K−1 at approximately 400 K, with no clear signature of Umklapp scattering observed in the whole measurement temperature range.

Nanowire Thermometers.

A Silicon Nanowire Heater and Thermometer

Abnormal resistance–temperature characteristic of the melting Bi nanowires

Bimetallic MoNi/WNi nanoalloys for ultra-sensitive wearable temperature sensors

Nanothermometer Using Single Crystal Silver Nanospheres

Single Silicon Nanowires As Inherent Heaters and Thermometers for Thermal Conductivity Measurements

Single Semiconducting Zinc Oxide Nanowire Based Device for Thermal and Airflow Sensing

Highly Sensitive Temperature Probe Fabricated by High Aspect Ratio Eu-BTC Nanowire

An Experimental Method to Estimate the Temperature of Individual Nanowires

A Modified High-Resolution TEM for Thermoelectric Properties Measurements of Nanowires and Nanotubes

High Sensitivity Temperature Sensor Based on A Long, Suspended Single-Walled Carbon Nanotube Array

Measuring Nanowire Thermal Conductivity at High Temperatures

Nanowire-based nanogap electrodes by annealing of multisegmented Pt/Au/Pt nanowires in air

FABRICATION AND CHARACTERIZATION OF Ni–Mn–Si–Al–O NTC THERMISTOR AND ITS APPLICATION AS TEMPERATURE WIRE SENSOR

Nanotube thermometer

In operando nanothermometry by nanodiamond based temperature sensing

Long Term Stability of Nanowire Nanoelectronics in Physiological Environments

Sensing Properties Of A Novel Temperature Sensor Based On Field Assisted Thermal Emission

Hot-wire Probe Based on Carbon Nanotube Strands

Nanoscale Thermal Management of Single Sno2 Nanowire: Pico-Joule Energy Consumed Molecule Sensor

Single Nanowire-Based Fluorescence Lifetime Thermometer for Simultaneous Measurement of Intra- and Extra-Cellular Temperatures