Abstract:Electrical characterization of semiconducting oxide nanowires (NWs) is mostly performed using complex techniques, which necessitates a series of costly nanofabrication procedures. In this work, with the aim to provide a low-cost, feasible, facile, and reproducible approach for enabling the study of NW electrical properties, we report direct electrical measurements on individual and overlapped suspended zinc oxide NWs (ZnO NWs). We have succeeded in constructing both two- and three-terminal devices simply by employing tungsten (W) nanoprobes with the aid of a nanomanipulation system embedded inside a scanning electron microscope’s vacuum chamber. Stable contacts were established using the Joule heating effect and e-beam exposure at the junctions between the NW and the pre-cleaned W tips. P-channel field-effect transistor devices were achieved with an on–off current ratio of ∼101, a threshold voltage (>1.5 V), a transconductance of ∼16 μS, a sub-threshold swing of ∼220 mV/decade, and field-effect carrier mobility roughly estimated to be around 926.4 cm2/(V·s) after correction for contact resistances/optimization. The average resistivity of ZnO NWs was calculated to be ∼2.23 × 10–2 Ω·cm for NWs with diameters between 70 and 500 nm. Besides, we have demonstrated a contact resistance of ∼19.60 kΩ and a Schottky barrier height of ∼0.37 eV present at W/ZnO NW interfaces. The contact resistance between two overlapped ZnO NWs was estimated to be ∼283 kΩ, which is relatively higher than that offered between W/ZnO NWs. This work provides a solid experimental procedure to address true intrinsic electrical properties at metal/semiconductor interfaces, and our findings have potential applications in next-generation 3D suspended ZnO NW-based nanoelectronic devices.

Single Semiconducting Zinc Oxide Nanowire Based Device for Thermal and Airflow Sensing

Nanowire Thermometers.

ZnO Nanowire and $\hbox{ws}_{2}$ Nanotube Electronics

Simultaneous Electrical and Thermoelectric Parameter Retrieval Via Two Terminal Current–Voltage Measurements on Individual ZnO Nanowires

ZnO nanotube-based dye-sensitized solar cell and its application in self-powered devices.

Low-temperature chemical solution route for ZnO based sulfide coaxial nanocables: general synthesis and gas sensor application

Electrical Actuation and Readout in a Nanoelectromechanical Resonator Based on a Laterally Suspended Zinc Oxide Nanowire

Single nanowire nanosensors: Fabrication and detailed studies

High Sensitivity Temperature Sensor Based on A Long, Suspended Single-Walled Carbon Nanotube Array

Piezoelectric field effect transistor and nanoforce sensor based on a single ZnO nanowire.

Fabrication of a Single CuO Nanowire-based Gas Sensor Working at Room Temperatur

Modeling and Experimental Study of Nanoelectromechanical Oscillator Using Single Zinc Oxide Nanowire

Enhanced P-Type NO2-sensing Properties of ZnO Nanowires Utilizing CNTs Electrode

Characterization of Electrical Properties of Suspended ZnO Nanowires Using a Nanorobotic Manipulation System Inside a Scanning Electron Microscope for Nanoelectronic Applications

Enhanced performance of flexible ZnO nanowire based room-temperature oxygen sensors by piezotronic effect.

Room Temperature CO Gas Sensing Using Zn-doped In2O3 Single Nanowire Field Effect Transistors

Realization and characterization of nano electromechanical devices based on ZnO nanowires

Fabrication and Characterization of ZnO Single Nanowire-Based Hydrogen Sensor

Humidity sensing properties of a single Sb doped SnO2 nanowire field effect transistor

Oxygen Sensing Characteristics of Individual ZnO Nanowire Transistors

Zinc oxide nanowire electromechanical oscillator