Abstract:<math>{101¯2}</math> twins were introduced into the magnesium (Mg) plate AZ31 via pre-rolling along its transverse direction. The plates, both with and without the pre-induced <math>{101¯2}</math> twins, were subjected to uniaxial tension along different directions. Using crystal plasticity modeling, we found that the strengthening effect of the pre-induced <math>{101¯2}</math> twins on the macroscopic flow stress primarily arised from the increased slip resistance caused by the boundaries, rather than the orientation hardening due to the twinning reorientation (although the latter did make its contribution in some specific loading directions). Besides, the pre-existing <math>{101¯2}</math> twins were found, by both experiments and simulation, to promote the activity of prismatic 〈a〉 and pyramidal 〈c + a〉 in the parent matrix of the material. Further analysis showed that the enhanced non-basal slip activity is related to the <math>{101¯2}</math> twin boundaries' low micro Hall-Petch slope ratios of non-basal slips to basal slip. With the critical resolved shear stress (CRSS) obtained from crystal plasticity modeling and the orientation data from EBSD, a probability-based slip transfer model was proposed. The model predicts higher slip transfer probabilities and thus lower strain concentration tendencies at <math>{101¯2}</math> twin boundaries than that at grain boundaries, which agrees with the experimental observation that the strain localization was primarily associated with the latter. The present findings are helpful scientifically, in deepening our understanding of how the pre-induced <math>{101¯2}</math> twins affect the strength and slip activity of Mg alloys, and technologically, in guiding the design of the pre-strain protocol of Mg alloys.

Investigation of the twin-induced adiabatic shear bands evolution in a Mg-Al-Mn alloy under ballistic impact

Simulation of Ballistic Performance of Coarse-Grained Metals Strengthened by Nanotwinned Regions

Influence of pre-twinning on adiabatic shear sensitivity of AM30 magnesium alloy

The Effect of Twins on Mechanical Properties and Microstructural Evolution in AZ31 Magnesium Alloy during High Speed Impact Loading

{ 10 1 ̄ 2 } twin–twin intersection-induced lattice rotation and dynamic recrystallization in Mg–6Al–3Sn–2Zn alloy

Microstructural Characteristics and Formation Mechanism of Adiabatic Shear Bands in Al–Zn–Mg–Cu Alloy under Dynamic Shear Loading

Multiple Adiabatic Shear Bands in Ti–6Al–4V Targets under Ballistic Impact

Application of machine learning to assess the influence of microstructure on twin nucleation in Mg alloys

The Dislocation-Twin Interaction and Evolution of Twin Boundary in AZ31 Mg Alloy

Adiabatic shear instability in a titanium alloy: Extreme deformation-induced phase transformation, nanotwinning, and grain refinement

Twinning dominated microstructural evolution in tungsten under impact loading

On the strengthening and slip activity of Mg-3Al-1Zn alloy with pre-induced { 10 1 ̄ 2 } twins

Two-dimensional evolution of temperature and deformation fields during dynamic shear banding: In-situ experiments and modeling

Microstructure evolution and characterization of the adiabatic shear bands in AZ31 magnesium alloy

Effect of twinning on the deformation behavior of an extruded Mg-Zn-Zr alloy during hot compression testing

The Effect of Tension Twin on the Dynamic Recrystallization Behavior in Polycrystal Magnesium by Atomistic Simulation

Formation of incoherent deformation twin boundaries in a coarse-grained Al-7Mg alloy

Quantitative investigation on the {10–12} twinning-detwinning behavior and twinning transfer of an extruded Mg-2.8Y sheet during compression-tension loading via quasi-in-situ EBSD observation

Investigation on the ballistic induced nanotwinning in the Mn-free Fe27Co24Ni23Cr26 high entropy alloy plate

Microstructure Evolution and Selection Behavior of Twin Variants of Mg-5Gd-3Y-0.5Zr Alloy during Secondary Deformation

Effects of {10-12} Twin Boundary on Nanotribological Behavior of Pure Mg: A Molecular Dynamics Simulation