Abstract:Al–Fe alloys have drawn attention of researchers for many decades since Fe is the most common impurity in Al that, because of its low solid solubility, forms brittle aluminides that affect the mechanical properties. Thus, it is interesting to provide microstructure control of these intermetallics and achieve high strength, thermal stability, and high electrical conductivity. High-pressure torsion (HPT) has been applied to an Al–2%Fe alloy with two different eutectic phases containing Al 6 Fe and Al 3 Fe intermetallics, to refine, disperse and partially dissolve them. The microstructure after HPT processing at different levels of imposed strain was observed using aberration-corrected high-resolution scanning/transmission electron microscopy (HR-S/TEM) to perform a detailed analysis of the dispersion of intermetallic phases and their orientation relationships with the Al matrix. The precipitates from the supersaturated solid solution achieved by post HPT aging, responsible for age-hardening were also studied in detail. Fragmentation of secondary Al 3 Fe and Al 6 Fe phases occurs down to sizes in the nano-scale and a fine dispersion of particles with coherency with the matrix in lattice planes with similar spacing (low misfit strain) was observed even after high straining by HPT. Semi-coherent Al 6 Fe is the dominant precipitate in the peak-aged condition and phase transformation of the particles from Al 6 Fe to Al 3 Fe occurs with aging. The Al 3 Fe particles loose coherency as they grow in size. It was possible to explain the age hardening effect with respect to the coherency and orientation relationship of the Fe-containing particles in the nano-scale, by a similar mechanism for Al alloys with miscible elements, which has not been reported for ultrafine-grained Al–Fe alloys to date.

Nonequilibrium solidification of Fe-P alloys

Non-equilibrium solidification of bulk undercooled Ni–P eutectic alloys

Experimental Study of High Temperature Phase Equilibria in the Iron-Rich Part of the Fe-P and Fe-C-P Systems

Relationship between the Crystallographic Structure of Electrodeposited Fe-P Alloy Film and its Thermal Equilibrium Phase Diagram

Phase-field Simulation of Effect of Phase-field Parameters on Solidification Process of Multicomponent Alloys

Effects of cooling rate on the microstructure control and liquid–liquid phase separation behavior of Cu–Fe–P immiscible alloys

Critical cooling rate for the glass formation of ferromagnetic Fe40Ni40P14B6 alloy

Theoretical Study of Particle Dissolution during Homogenization in Cu–Fe–P Alloy

In-situ observations of solidification process of Fe–Al–Ta eutectic alloy

Thermodynamic properties and phase equilibria in the Fe–P system

Modeling of temperature-concentration ranges of phase stability and liquidus surface in the ternary Fe–P–C system and phase composition experimental study

Cooling Rate and Compositional Effects on Microstructural Evolution and Mechanical Properties of (CoCrCuTi)100−xFex High-Entropy Alloys

Rapid solidification of undercooled FeCoNiCu multi-principal element alloy: Mechanical and tribological properties

High-resolution electron microscopy study of particle dispersion and precipitation in a nanostructured Al–2%Fe alloy

Formation of ferromagnetic bulk amorphous Fe40Ni40P14B6 alloys

The Improvement in Ordered Phase Transformation Temperature of Cu75Fe05Pd20 Alloy for Advanced Engineering Applications

The Microstructure Evolution of a Fe-Ni-P-B Soft Magnetic Alloy Solidified at Different Undercooling

On the Solidification and Phase Stability of a Co-Cr-Fe-Ni-Ti High-Entropy Alloy

Solidification and microstructure investigation on as-cast and annealed hypoeutectic Ti–Fe alloys

Compaction of bulk amorphous Fe40Ni40P14B6 alloys

Effect of Thermomechanical Processing on the Microstructure and Properties of a Cu-Fe-P Alloy