Abstract:The unsteady behavior of a sweeping impinging jet is measured experimentally using time-resolved particle image velocimetry. For the configuration with a jet-to-wall spacing ratio L/dh = 8, an approximately linear increase in the sweeping frequency is observed with Reynolds numbers (Re) between 2.7 x 10(3) and 9.3 x 10(3), especially at high Reynolds numbers. The saturation of the sweeping jet, at which the maximum deflection angle is reached, occurs at Re = 6.7 x 10(3). Special focus is then placed on the spatial and temporal variations of unsteady flow fields at two Reynolds numbers Re = 4.0 x 10(3) and 9.3 x 10(3). The unsteady behavior in the near-exit region is first compared. At a higher Reynolds number, the jet in the near-exit region remains at the maximum deflection angle for a longer time during one oscillation cycle with more concentrated jet momentum, resulting in a faster switching process. In the near-wall region at Re = 4.0 x 10(3), the sweeping impinging jet exerts a large region of influence due to the oscillation motion of the impact region along the wall. The time-averaged velocity components and velocity fluctuating components near the wall show double peaks on both outer sides and a minimum in the middle of the near-wall region. At Re = 9.3 x 10(3), due to the rapid and intensive sweeping process, the jet column breaks in the near-exit region, resulting in a weak flow in the middle of the near-wall region. Accordingly, the profiles of the time-averaged velocity components and velocity fluctuating components show higher double-peak values but an even lower minimum value. Finally, the state-of-the-art dynamic mode decomposition method is used to capture the main flow behavior of distinct frequencies at these two selected Reynolds numbers. Bounded by the breaking location of the jet column, the flow with a superharmonic oscillation frequency in the middle of the near-wall region disappears at Re = 9 x 10(3). Therefore, the energetic flow patterns are found to be more evenly distributed in the near-exit region than in near-wall region. The phase correlation between the captured flow patterns is determined by projecting the phase-averaged flow fields onto the most energetic modes.

Annular impinging jets controlled by synthetic jets inducing a swirling flow character

Control of Vortex Shedding from Two Side-by-side Cylinders Using a Pair of Tangential Jets

Control of flow separation over a circular cylinder using synthetic jet

Flow Control of Annular Compressor Cascade by Synthetic Jets

Turbulent round jet control using two steady mini -jets

Numerical study on flow separation control of cascades with synthetic jet using dynamic mesh method

Mini-Jet Controlled Turbulent Round Air Jet

Sweeping jet control of flow around a circular cylinder

Experimental Investigation of Flow Regimes of Axisymmetric and Planar Opposed Jets

Interaction of dual sweeping impinging jets at different Reynolds numbers

An experimental study of the flow structure in arrays of cold bidirectional swirling jets

Jet flow structure under the perturbation of two unsteady microjets

Flow characteristics in a semi-confined circular-pipe impinging jet

Unsteady Behavior of a Sweeping Impinging Jet: Time-resolved Particle Image Velocimetry Measurements

Experimental Investigation of Flow Dynamics of Sweeping Jets Impinging Upon Confined Concave Surfaces

Open- and Closed-Loop Control of a Turbulent Round Jet Based on Fluidic Means

Analysis of the three-dimensional swirling and non-swirling jet impingement using a turbulence model with cross-diffusion correction

Experimental study on flow and turbulence characteristics of jet impinging on cylinder using three-dimensional Lagrangian particle tracking velocimetry

Hysteresis and Precession of a Swirling Jet Normal to a Wall.

Vortex-enhanced mixing through active and passive flow control methods

Visualizing Three-Dimensional Effects of Synthetic Jet Flow Control