Abstract:Braiding is an attractive manufacturing method for tubular elements such as hollow shafts and struts. One of the main challenges however is the integration of suitably performing end-fittings. Recent advances in additive layer manufacture have enabled the fabrication of end-fittings which can be ‘co-impregnated’ or ‘co-cured’ with the fibre preform in a single step, i.e. without the need for secondary adhesive bonding. This requires the introduction of protrusions onto the surface of the end-fitting to promote mechanical interlocking with the fibres. However, the lack of accurate modelling tools for the simulation of this manufacturing process means that much empiricism is currently used in the design of such structures. A novel numerical framework is presented here for the full-scale simulation of the braiding process over structured end-fittings. Nonlinear finite element analysis is applied at the meso-scale, with strands of beam elements representing individual yarns and meshed surfaces modelling the mandrel and tooling. Penalty-based contact formulations are then used to simulate all inter-yarn and yarn-metal interactions, enabling detailed predictions of fibre paths around surface protrusions. In order to verify and validate this numerical framework, a series of full-scale braiding experiments was conducted using additively-manufactured thermoplastic mandrels. Final braid patterns as well as the occurrence of braid imperfections were investigated and compared to model predictions. It is shown that the proposed modelling strategy reproduces well the trends observed experimentally in terms of final braid quality. A parametric study was then conducted on the effects of initial end-fitting alignment with respect to oncoming yarns, suggesting that better control over this parameter could reduce considerably the occurrence of braid imperfections.

Influence of process induced defects for biaxial carbon fiber braids

Experimental and numerical studies on the braiding of carbon fibres over structured end-fittings for the design and manufacture of high performance hybrid shafts

Process-structure-performance modelling and progressive damage analysis of 3D rotary four-directional rectangular braided composites under tensile load

Non-Axisymmetric Overbraiding Process Modeling Based on Enhanced Kinematic Models

Numerical investigation of tensile behavior of three-dimensional six-directional braided composites

Effects of yarn interlacement in diamond triaxial braid on its patterns and tensile properties

X-ray microtomography analysis of the damage mechanisms in 3D circular braided carbon fiber/epoxy resin composite tubes under axial impact compression

Analysis of the influence of yarn angle on the mechanical behaviors of cured woven composites

Spatial distribution of yarns and mechanical properties in 3D braided tubular composites

Effect of Braiding Architectures on the Mechanical and Failure Behavior of 3D Braided Composites: Experimental Investigation

The effect of interface properties on the mechanical behaviour of 3D braided composites under unidirectional tensile loading

Investigation of parameterized braiding parameters and loading directions on compressive behavior and failure mechanism of 3D four-directional braided composites

Parametric analyses on multiscale elastic behavior of 3D braided composites with pore defects

Shear deformation characteristics under tensile stress during forming of tubular braided fabrics

Experiment investigation on biaxial tensile strength of 3D in-plane braided C/C composites

Examination of voids and geometry of bio-based braided composite structures

An Analytical Model for Predicting the Elastic Properties of Triaxially Braided Composites

Numerical Analysis of Free-Edge Effect on Size-Influenced Mechanical Properties of Single-Layer Triaxially Braided Composites

Unit-cell geometry and mechanical properties of three-dimensional seven-directional braided composites

Analysis of in-plane compression failure mechanism in carbon fiber braided composite with different off-axial angles

Nonlinear Mechanical Property of 3D Braided Composites with Multi-Types Micro-Distortion: A Quantitative Evaluation