Abstract:Ground-mounted solar systems utilize huge agricultural land because of their high demand. The application/installation of Solar Panels on high rooftop structures can help save agricultural land. However, rooftop structures are vulnerable to high wind-loading conditions. There is no clear guidance available in the literature for finding additional stresses, which are produced by high roof-mounted solar panels due to strong wind loading. This simulation study comprises computational fluid variant (CFX) testing of solar panels and structural analysis of high rooftop structures at different wind velocities of ±7.53, ±15, ±25, ±35, and ±45 m/s. In this simulation study factors of safety (FoS) and displacement against these velocities for all elements of the structure are computed and presented. The truss is the most vulnerable even at the minimum wind load. The FoS for the truss is 0.41 and the displacement is 51.6 mm at a velocity of 7.53 m/s. The mounting structure fails at the velocity of -15 m/s as the resulting FoS and displacement are 0.72 and 58.26 mm, respectively. Based on the analysis, it has been determined that the Channel and Column structures can withstand speeds of up to ±25 m/s without exceeding the threshold limit. The Factor of Safety (FoS) for the Channel and Column at +25 m/s are 15 and 14.27, respectively, while the corresponding deformations are 0.43 mm and 4.59 mm. At -25 m/s, the FoS for the Channel and Column are 1.26 and 4.8, respectively. Overall, these results indicate that the Channel and Column structures have a good margin of safety and can withstand typical wind loads without failure. Meanwhile, deformations are 13.02 mm and 4.59 mm, respectively. Further, results give that the new proposed design of the mounting structure and truss can withstand up to the threshold velocity level of 25 m/s. Hence, investing in an existing structure can save useful agricultural land.

Wind‐induced response and stow position analysis of the flat roof Parabolic Solar Collector (FRPSC)

Probability characteristics and extreme value analysis of base shear force of flat roof parabolic solar condenser (FRPSC)

NUMERICAL SIMULATION OF WIND PRESSURES ON CANTILEVER GRANDSTAND ROOFS

Study on wind-induced dynamic responses and wind tunnel test for a large-span double-layered roof structure

Numerical Simulation of Wind Load on Solar Thermal Power Station with 100 MW Output

Multiphysics-coupled Study of Wind Load Effects on Optical Performance of Parabolic Trough Collector

Experimental Investigation of the Parapet Effect on the Wind Load of Roof-Mounted Solar Arrays

Field measurements reveal insights into the impact of turbulent wind on loads experienced by parabolic trough solar collectors

Experimental Investigation of Wind Loads on Roof-Mounted Solar Arrays

A Review on Aerodynamic Characteristics and Wind-Induced Response of Flexible Support Photovoltaic System

Experimental study on effect factors of wind-induced response of flexible photovoltaic support structure

Analysis of wind-induced vibration effect parameters in flexible cable-supported photovoltaic systems: A case study on ground anchor with steel cables

Analysis of wind-induced responses of landing assembled Chinese solar greenhouses

Dynamic response analysis of a whole steel frame solar greenhouse under wind loads

Wind Load and Wind-Induced Vibration of Photovoltaic Supports: A Review

Wind load effect study on large-aperture parabolic trough collector mirror fields

Evaluation of wind load effects on solar panel support frame: A numerical study

Wind Loads on Solar Panels Mounted on Facade of High-Rise Residential Building

Wind load characteristics of photovoltaic panel arrays mounted on flat roof

Wind tunnel test study on wind load variation law of Point Focus Solar Furnace

Investigation of wind loading characteristics of roof-mounted solar panels on tall buildings