Abstract:A detailed computational investigation of the wind field around tilted solar modules mounted on a large building roof has been undertaken, utilizing the Reynolds-Averaged Navier-Stokesv (RANS) approach supplied with the SST k − ω turbulence model. The study investigated the flow field for various tilt angle of modules at normal wind directions relative to the wall. Then the shape factors and moment coefficients of modules were explored. The results show that the recirculation vortex generated by the building edge is disintegrated to smaller local vortices. With the increasing of the tilt angle, an increasing number of local vortices emerged at the leading rows, leading to a relatively large wind pressure and shape factor at the corner of the array. In most tilt angles at 0° and 180° wind direction the shape factors are negative. However, for the 40° and 55° tilt angles at 180° wind direction, the shape factors on the lower surfaces are positive, due to the dominating of approaching flow rather than the local vortices. The array is divided into six zones based on the distribution of shape factors. As the shape factors on upper and lower are similar, the shape factors in most zones for tilt angles from 5° to 55° are quite small. However, shape factors in the leading row for 30°, 40° and 55° are relatively large. This indicates that the shading effect of front rows can significantly reduce the shape factors of the rear rows. Compared to the values calculated by Chinese, American and Japanese standards, the shape factors by simulation are quite small. The moment induced by nonuniform wind pressure, which is often ignored in the literature and standards, is quite large at the leading zones, with a maximum of 0.28 for 55° tilt angle. Ignoring the wind induced moment on the leading zones may make the wind resistance design of the solar module support structure unsafe.

Probability characteristics and extreme value analysis of base shear force of flat roof parabolic solar condenser (FRPSC)

Numerical Simulation of Wind Load on Solar Thermal Power Station with 100 MW Output

NUMERICAL SIMULATION OF WIND PRESSURES ON CANTILEVER GRANDSTAND ROOFS

Wind‐induced response and stow position analysis of the flat roof Parabolic Solar Collector (FRPSC)

Failure Mechanisms and Load Paths in a Standing Seam Metal Roof under Extreme Wind Loads

Analysis and Practical Determination of Wind-Load Shape Factors for Low-Rise Hip Roofed Buildings

DETERMINATION OF WIND LOADS ON CANTILEVERED ROOFS OF STADIUM GRANDSTAND

Experimental Investigation of the Parapet Effect on the Wind Load of Roof-Mounted Solar Arrays

Experimental Investigation of Wind Loads on Roof-Mounted Solar Arrays

Wind Loads on Solar Panels Mounted on Facade of High-Rise Residential Building

Development of joint probability distribution of wind speed and direction using long-term monitoring data

Probabilistic Method for Wind Speed Prediction and Statistics Distribution Inference Based on SHM Data-Driven

Investigating the Non-Gaussian Property and Its Influence on Extreme Wind Pressures on the Long-Span Cylindrical Roof

The Impact of Installation Angle on the Wind Load of Solar Photovoltaic Panels

Hermite Extreme Value Estimation of Non-Gaussian Wind Load Process on a Long-Span Roof Structure

Statistical extrapolation methods and empirical formulae for estimating extreme loads on operating wind turbine towers

Peak Factor Estimation Method of Non‐gaussian Wind Pressures on Long‐span Tri‐centered Cylindrical Roof Structures

Wind load characteristics of photovoltaic panel arrays mounted on flat roof

Research on probabilistic analysis of trapezoidal triangle truss

Analysis of mechanical stress and structural deformation on a solar photovoltaic panel through various wind loads

Computational Investigation of Wind Loads on Tilted Roof-Mounted Solar Array