Abstract:A detailed computational investigation of the wind field around tilted solar modules mounted on a large building roof has been undertaken, utilizing the Reynolds-Averaged Navier-Stokesv (RANS) approach supplied with the SST k − ω turbulence model. The study investigated the flow field for various tilt angle of modules at normal wind directions relative to the wall. Then the shape factors and moment coefficients of modules were explored. The results show that the recirculation vortex generated by the building edge is disintegrated to smaller local vortices. With the increasing of the tilt angle, an increasing number of local vortices emerged at the leading rows, leading to a relatively large wind pressure and shape factor at the corner of the array. In most tilt angles at 0° and 180° wind direction the shape factors are negative. However, for the 40° and 55° tilt angles at 180° wind direction, the shape factors on the lower surfaces are positive, due to the dominating of approaching flow rather than the local vortices. The array is divided into six zones based on the distribution of shape factors. As the shape factors on upper and lower are similar, the shape factors in most zones for tilt angles from 5° to 55° are quite small. However, shape factors in the leading row for 30°, 40° and 55° are relatively large. This indicates that the shading effect of front rows can significantly reduce the shape factors of the rear rows. Compared to the values calculated by Chinese, American and Japanese standards, the shape factors by simulation are quite small. The moment induced by nonuniform wind pressure, which is often ignored in the literature and standards, is quite large at the leading zones, with a maximum of 0.28 for 55° tilt angle. Ignoring the wind induced moment on the leading zones may make the wind resistance design of the solar module support structure unsafe.

Wind load characteristics of photovoltaic panel arrays mounted on flat roof

Wind loading characteristics of solar arrays mounted on flat roofs

Investigation of wind loading characteristics of roof-mounted solar panels on tall buildings

Experimental Investigation of Wind Loads on Roof-Mounted Solar Arrays

Effects of building parameters on wind loads on flat-roof-mounted solar arrays

Wind Loads on Solar Panels Mounted on Facade of High-Rise Residential Building

Experimental Investigation of the Parapet Effect on the Wind Load of Roof-Mounted Solar Arrays

Wind loading characteristics and roof zoning of solar arrays mounted on flat-roofed tall buildings

Wind Loads on a PV Array

Wind Loads on Low-Profile, Tilted, Solar Arrays Placed on Large, Flat, Low-Rise Building Roofs

Aerodynamic mechanisms for wind loads on tilted, roof-mounted, solar arrays

Wind loads on roof-mounted isolated solar panels of tall buildings through wind tunnel testing

Wind loads on a low-rise gable roof with and without solar panels and comparison to design standards

Wind Loads on a Solar Panel at High Tilt Angles

Experimental Investigation of Wind Pressures on Photovoltaic (PV) Panel Installed Parallel to Residential Gable Roof

Numerical study of wind loads on low-rise gable-roofed building roofs——Analysis of roof pitch and height-width ratio effects

Computational Investigation of Wind Loads on Tilted Roof-Mounted Solar Array

Wind loads on a solar PV panel with side plates

Experimental study of aerodynamic loads on ground-mounted solar panel arrays: The panel spacing and inclination angle effect

Wind Loads on Rooftop Solar Panels for a Flat-roof Cubic Building