Abstract:This paper reports on a comprehensive study of the effect of single-walled carbon nanotube (SWCNT) on the alternating current (AC) conductivity, thermal and morphological properties of the unsaturated polyester based glass fiber reinforced polymer composite (GFRPC). AC conductivity measurements were carried out using the impedance spectrum and thermal measurements were carried out using differential scanning calorimetry (DSC) at a temperature range of 24-900 °C and heating rates of 20 °C/min. Impedance results showed that the conductivity behavior in the nanotube-loaded composite laminate obeys a Jonscher-type mechanism. At low frequencies, the conductivity value remains almost constant for the doped material and takes the value of 10-5 S/cm. It is observed that the AC conductivity starts to increase after the critical frequency value of approximately 103 Hz and increases up to 10-2 S/cm due to hopping and tunneling mechanisms caused by space charge polarization accumulated in the local regions at high frequencies. The pure material with an insulating nature also exhibited a typical insulating behavior. Thermal testing showed that nanotube reinforcement increases thermal conductivity in three different directions. DSC thermocurves analysis also revealed that the addition of carbon nanotubes increased the glass transition temperature of the material from 180°C to 190°C. The scaling and fractal analysis methods were also applied to obtain hetero morphological structure of materials. The fractal analysis results indicated that carbon nanotube doping to the standard sample increases the coating rates, scalability and heterogeneity of the solid phase surface of the sample. The coating rates of composite surfaces were calculated as 45% and 36%, respectively. Morphology analysis revealed that the probability of finding surface particles for the nanotube-doped sample decreased compared to the undoped sample, but the fractal dimension value increased. While this value was 1.83 in the pure sample, it increased to 1.92 in the nanotube material.

The effect of low temperature neutron irradiation and annealing on the thermal conductivity of advanced carbon-based materials

Effects of Carbon Nanotubes and Carbon Fiber Reinforcements on Thermal Conductivity and Ablation Properties of Carbon/phenolic Composites

The Microstructural and Hardness Changes of Tungsten Fiber after Au2+ Irradiation

High temperature annealing of irradiated nuclear grade graphite

Dimensional Changes and Thermal Conductivity by Annealing and Its Relation to the Defect Concentration and Stored Energy Release of Neutron-Irradiated Graphite

Microstructural changes induced in advanced tungsten grades under high temperature neutron irradiation

Effect of Neutron-Irradiation on Thermal Conductivity, Electric Resistivity and Thermal Expansion of Boron Carbide

Effects of Current Annealing on Thermal Conductivity of Carbon Nanotubes

Effect of annealing processes on microstructure, mechanical properties and conductivity of Cu-12%Ag alloy composite-reinforced by fibers

Effects of extreme low temperatures on the impact behavior of boron nitride nanofillers added carbon fiber/epoxy composite tubes

The effect of high-temperature annealing on the structure and electrical properties of well-aligned carbon nanotubes

Thermal Effects in Ion Irradiated Ti2AlC and Ti3SiC2

Thermal Annealing of C Ion Irradiation Defects in Nuclear Graphite Studied by Positron Annihilation

Effect of annealing on the microstructure behavior of D+-irradiated W-2vol.%TiC composite prepared by wet-chemical method

Effects of Heat-Treatment on the Microstructure, Electromagnetic Wave Absorbing Properties, and Mechanical Properties of SiCN Fibers

High Temperature Effects on Irradiation Damage of Ti2AlC

Irradiation Treatment of Multiwalled Carbon Nanotubes and Its Effect on the Thermal Properties of Their Composites with Epoxy Resin

Mechanical characterization of synergistic thermal and irradiation effects on fracture resistance of stainless steel

Effect of Thermal Ageing on the Impact Damage Resistance and Tolerance of Carbon-Fibre-Reinforced Epoxy Laminates

Effects of Temperature on the Fibre Matrix Interfacial Shear Strength of Carbon Nanotube Grafted Carbon Fibre Reinforced Heat Resistant Resin

The Effect of Single Walled Carbon Nanotubes on Conductivity and Thermal Properties of Glass Fiber Reinforced Composites