Abstract:Monocore powder-in-tube MgB2 strands were cold-drawn and heat-treated at 600C and 700C for times of up to 71 hours and structure-property relationships examined. Drawing-induced elongation of the Mg particles led, after HT, to a textured macrostructure consisting of elongated polycrystalline MgB2 fibers separated by elongated pores. The superconducting Tc, Jc and Fp were correlated with the macrostructure and grain size. Grain size increased with HT time at both 600C and 700C. Jc and hence Fp decreased monotonically but not linearly with grain size. Overall, it was observed that at 700C, the MgB2 reaction was more or less complete after as little as 30 min; at 600C, full reaction completion did not occur until 71 h. into the HT. Transport, Jct(B) was measured in a perpendicular applied field, and the magnetic critical current densities, Jcm\bot(B) and Jcm{\phi}(B), were measured in perpendicular and parallel (axial) applied fields, respectively. Particularly noticeable was the premature dropoff of Jcm\bot(B) at fields well below the irreversibility field of Jct(B). This effect is attributed to the fibrous macrostructure and its accompanying anisotropic connectivity. Magnetic measurements with the field directed along the strand axis yielded a critical density, Jcm\bot(B), for current flowing transversely to the strand axis that was less than and dropped off more rapidly than Jct(B). In the conventional magnetic measurement, the loop currents that support the magnetization are restricted by the lower of Jct(B) and Jcm{\phi} (B). In the present case the latter, leading to the premature dropoff of the measured Jcm(B) compared to Jct(B) with increasing field. This result is supported by Kramer plots of the Jcm{\phi} (B) and Jct(B) data which lead to an irreversibility field for transverse current that is very much less than the usual transport-measured longitudinal one, Birr,t.

Enhanced electrophoretic deposition and heat treatment study of MgB 2 superconducting coatings from iodine-stabilized colloidal precursors

Biaxial Strain Engineering on the Superconducting Properties of MgB2 Monolayer

Influences of Heat Treatment and Doping on Microstructure and Superconducting Properties of MgB2 Superconductor

High temperature heat treatment of B precursor and P.I.T. process optimization to increase Jc performances of MgB2-based conductor

Heat Treatment-Induced Microstructure and Property Evolution of Mg/Al Intermetallic Compound Coatings Prepared by Al Electrodeposition on Mg Alloy from Molten Salt Electrolytes

High-energy ball milling and synthesi temperature study to improve superconducting properties of MgB2 ex-situ tapes and wires

Coating Thick MgB 2 Layer on Stainless Steel Substrate

Influence of the Preparation Process on Microstructure, Critical Current Density and Tc of MgB2 Powder-In-Tube Wires

Investigation of Layered Structure Formation in MgB2 Wires Produced by the Internal Mg Coating Process under Low and High Isostatic Pressures

Drawing induced texture and the evolution of superconductive properties with heat treatment time in powder-in-tube in-situ processed MgB2 strands

High-Temperature Synthesis of Superconducting MgB2 Materials in a Centrifuge

Electrochemical synthesis of superconducting MgB2 thin films: a novel potential technique

A Method to Fabricate Biaxially Textured MgO Buffer Layer for HTS Coated Conductor

Electron Microscopic Analysis of Josephson Junction of Mgb2 Superconducting Material with High Critical Temperature

Sonochemical Modification of the Superconducting Properties of MgB2

Deposition of Mgb2 Superconducting Films on Different Metal Substrates

Two Patterning Techniques for Superconducting MgB2 Films by Wet Etching

Solution Fabrication of A Superconducting Mgb2 Coated Conductor on Stainless Steel

A Study on the Components of MgB2 Thick Film Prepared Via HPCVD

In Situ Epitaxial MgB2 Thin Films for Superconducting Electronics

Influence of Electron-Beam Annealing Duration on MgB<sub>2</sub> Film Superconductivity