Abstract:The effect of deep cryogenic cycle treatment (DCT) on Zr41.2Ti13.8Cu12.5Ni10Be22.5 (Vit-1) bulk metallic glass (BMG) prepared from high-purity raw materials was investigated. After DCT, no obvious rejuvenation of the samples was detected. With an increasing number of cryogenic cycles, the hardness of the samples first decreased and then increased, the room-temperature compression plasticity first increased and then generally remained unchanged, and the impact toughness underwent almost no obvious change. The absence of rejuvenation was attributed to the high fragility index (47-50) and high glass forming ability (GFA) of the material. As lower purity of the raw materials is expected in practical applications, DCT of Vit-1 BMG prepared from low-purity raw materials was also performed. After DCT, the samples prepared with the lower-purity raw materials were clearly rejuvenated, and the room-temperature mechanical properties improved significantly.Both the compression plasticity and impact toughness reached peak values after 5 cryogenic cycles. The initial impurities (including Y and O) had a complex and comprehensive effect on the deformation mechanism of the BMG during DCT. Our findings indicate that the structural heterogeneity, fragility index, and GFA of the BMG alter the effect of DCT.

Significant rejuvenation of a deformed metallic glass contributed by shear band affected zones during cryogenic cycling

Rejuvenation of a deformed metallic glass dominated by immature shear band zones during cryogenic thermal cycling

Accelerating structural relaxation of shear band at ambient conditions through cryogenic thermal-cycling

Flow serrations of rejuvenation behaviour through cryogenic thermal cycling for Zr-based bulk metallic glass

Improving plasticity of the Zr46Cu46Al8 bulk metallic glass via thermal rejuvenation

Cryogenic thermal cycling induced simultaneous improvement of strength and ductility in a Zr-based bulk metallic glass composite

Effect of cryogenic cycling on mechanical properties of ZrTiCuNiBe bulk metallic glass

Cryogenic thermal cycling rejuvenation in metallic glasses: Structural and mechanical assessment

Mechanical Property and Structural Changes by Thermal Cycling in Phase-Separated Metallic Glasses

Anelastic-like nature of the rejuvenation of metallic glasses by cryogenic thermal cycling

Enhancing the plasticity of a Ti-based bulk metallic glass composite by cryogenic cycling treatments

Thermal Rejuvenation of an Mg-Based Metallic Glass

Efficient Rejuvenation of Heterogeneous {[(fe0.5co0.5 ) 0.75 B 0.2 Si0.05 ]96nb4 }99.9cu0.1 Bulk Metallic Glass Upon Cryogenic Cycling Treatment

Tailoring rejuvenation behavior of Zr-based metallic glass upon deep cryogenic cycling treatment

Evolution Path of Metallic Glasses Under Extensive Cryogenic Thermal Cycling: Rejuvenation or Relaxation?

Non-monotonic influence of cryogenic thermal cycling on rejuvenation and impact toughness of Ti-based bulk metallic glass composites

Influence of Deep Cryogenic Cycling on the Rejuvenation and Plasticization of TiZrHfBeCu High-Entropy Bulk Metallic Glass

Nanoscopic tribological characteristics of a cryogenically cycled Zr-based metallic glass

Contribution of cryogenic thermal cycling to the atomic dynamics in a La-based bulk metallic glass with different initial states

Defects controlled rejuvenation in the Zr47.5Cu47.5Al5 metallic glass

Deformation behavior of thermally rejuvenated Zr-Cu-Al-(Ti) bulk metallic glass