Abstract:Textile reinforced concrete (TRC) is a type of composite material with great potential in lightweight and thin-walled structural components bearing high capacity. In this study, TRC thin-plates with epoxy resin impregnated fibre (type 1) and non-impregnated fibre (type 2) were exposed to high temperatures from 35 degrees C to 800 degrees C with the unstressed residual test method. The processed TRC thin-plates were examined through four-point bending tests with the aim of building a foundation for a fire prevention code for TRC. The results demonstrate that the ultimate load of type 1 TRC thin-plates is relatively high and does not vary significantly when the target temperature is below 200 degrees C. The ultimate load of type 2 TRC thin-plates is lower than that of type 1, and does not vary significantly when the target temperature is below 400 degrees C; the turning point for the reduction of ultimate load is 400-500 degrees C, and 20% of loading capacity at normal temperature is maintained at 800 degrees C. Stripping damage to type 1 occurs along the interface and the damage is brittle. For a target temperature of 300 degrees C, epoxy resin is prone to deteriorate and the bursting ratio of the specimens was 100%. The damage feature of type 2 thin-plates is a slipping failure between fibre and mortar mixes, and significant ductile damage properties were observed during the damage process. The investigations were also accompanied by scanning electron microscope and alpha ray spectrometer analyses, which provided an additional basis for analysing the damaged sections of specimens. The results show that the surface flaws of the carbon filaments, matrix decomposition and the weak bond behaviour between the fibres and matrix are affected by elevated temperatures. These three factors may result in the decline of the bearing capacity of type 2 TRC thin-plates.

Residual Strengths of RC Beams Strengthened with Basalt and Carbon Textile Reinforced Mortars After Exposure to Elevated Temperatures

Experimental study on reinforced concrete beams strengthened with Basalt and Carbon Textile Reinforced mortars at elevated temperatures

Study on Shear Behavior of Concrete-polymer Cement Mortar at Elevated Temperature

Experimental Study on Axial Mechanical Behavior of Reinforced Concrete Stub Columns with Pre-Load after Exposure to High Temperatures

Effectiveness of TRC Jackets for the Strengthening of Concrete Columns after Elevated Temperatures: Experimental and Analytical Investigation

Residual Flexural Behaviour of RC Beams Strengthened with TRC after ISO 834 Exposure

Mechanical Properties and Microstructures of Steel-basalt Hybrid Fibers Reinforced Cement-based Composites Exposed to High Temperatures

Strengthening of Reinforced Concrete Beams with Textile-Reinforced Concrete

Experimental and Analytical Investigation of Crack Spacing and Width for Overlaid RC Beams at Elevated Temperatures

Residual bond‐slip behavior in reinforced concrete members exposed to elevated temperatures

Behaviour of steel-fiber reinforced concrete at elevated temperatures

Investigation on Concrete-Pcm Interface under Elevated Temperature: at Material Level and Member Level

Effect of high temperature on FRCM‐confined concrete

Experimental Investigation of Concrete Cylinders Confined with PBO FRCM Exposed to Elevated Temperatures

Mechanical behaviour of TRC thin-plates exposed to high temperature: experimental study

Concrete confinement with TRM versus FRP jackets at elevated temperatures

Effects of High Temperature and Substitution Rates of Fly Ash on the Mechanical Properties and Microstructures of Steel-Basalt Hybrid Fibers Reinforced Cementitious Composites

Experimental Evaluation of Carbon Reinforced TRC with Cement Suspension Matrix at Elevated Temperature

Residual bond strengths of epoxy and cement-bonded CFRP reinforcements to concrete interfaces after elevated temperature exposure

Experimental Investigation of the TRM-to-Masonry Bond after Exposure to Elevated Temperatures: Cementitious and Alkali-Activated Matrices of Various Densities

Mechanical behavior of textile reinforced concrete with newly developed mineral-impregnated carbon fabrics submitted to elevated temperatures