Comparative study on cutting performance of CFRP/Ti-laminated materials with flat end milling cutter and circular arc milling cutter in inclined angle milling
Jiaqiang Liu,Tao Chen,Wenyuan Xu,Guangyue Wang,Jianyi Zhang
DOI: https://doi.org/10.1007/s00170-024-14346-5
IF: 3.563
2024-09-10
The International Journal of Advanced Manufacturing Technology
Abstract:Carbon fiber reinforced polymer (CFRP) and titanium alloy (Ti-6Al-4V) have excellent mechanical properties and have been widely used in aviation, aerospace, and other fields. Due to the different characteristics of CFRP/Ti-laminated materials, there are differences in their processing parameters and material removal methods. Cutter wear and hole defects are prone to occur. To study the cutting performance of cutters in laminated materials, this paper adopts the inclined angle milling method to process CFRP/Ti-laminated materials. The cutting performance of flat end milling cutter and circular arc milling cutter was compared and analyzed through designed variable parameter experiments. A study was conducted on the axial force, cutter wear mechanism, hole quality, and micro-morphology of the hole wall of two cutters under the inclined angle milling method. The results show that under different processing parameters, the difference in axial force between the two cutters is small in the carbon fiber layer. However, there is a significant difference in the titanium layer, with the axial force of the circular arc milling cutter being smaller than that of the flat end milling cutter. As the number of holes increases, the wear of the flat end milling cutter is serious, and the cutting edge is broken. The wear area gradually expands from the cutter tip to the surrounding cutting edge. The wear of the circular arc milling cutter is relatively light, and the cutting edge is damaged. As the wear at the arc transition becomes dull, the wear area gradually extends to the surrounding cutting edge. As the cutters wear out, many burrs and tear damage appear at the CFRP exit of the flat end milling cutter. Many high burrs appeared at the exit of Ti-6Al-4V. Comparing the micro-morphology of the hole wall of the two cutters at different fiber cutting angles, the quality of the hole wall of the flat end milling cutter is worse than that of the circular arc milling cutter. Due to the arc transition structure of the circular arc milling cutter, the hole wall has obvious groove scratches, resulting in a decrease in the quality of the Ti-6Al-4V hole wall. In addition, compared with the flat end milling cutter, the surface roughness of the hole of the circular arc milling cutter is better.
engineering, manufacturing,automation & control systems