Abstract:The rheological properties of fresh cement pastes (FCPs) in the presence of superplasticizer were systematically investigated in this study where influential factors such as mix proportion including the water-to-cement (W/C) ratio and superplasticizer-to-cement (Sp/C) ratio, temperature, and time were discussed. The initial yield stress of FCPs with varied mix proportions and its development over time were tested at 0, 20, and 40 degrees C to characterize the rheological properties of the pastes. Measurements on the amount of adsorbed superplasticizer, zeta potential, particle size, microscopic observation, and calorimetry were performed to quantify the influences of superplasticizer on the microstructure of FCPs under varied mix proportions and temperatures. Results indicate that the initial yield stress of the pastes and its development over time evidently descend due to the plasticizing effect and retardation effect of superplasticizer. Higher temperature facilitates a sharper rise in the initial yield stress and the growth of yield stress with time while the effects of temperature are weakened in the case of high W/C ratio or Sp/C ratio. Higher temperature results in a larger adsorbed amount and a higher zeta potential, which is believed to result from the accelerated dissolution and hydration rate. The effects of W/C ratio, superplasticizer dosage, and temperature on the development of yield stress over time were integrated into the parameter of relative hydration degree. A generalized model to describe the evolution of yield stress was deduced by introducing the hydration index of relative hydration degree , which was verified by the experimental results that the yield stress ascended in a roughly linear fashion with 1/(1-).

Deformation capacity of fresh cement pastes

Influence of Superplasticizers on Early Age Drying Shrinkage of Cement Paste with the Same Consistency

Influence of Superplasticizer Type and Dosage on Early-age Drying Shrinkage of Cement Paste with Consideration of Pore Size Distribution and Water Loss

The Early-Age Drying Shrinkage of Cement-Based Materials with the Same Workability after Temperature Compensation

Rheological Behaviors of Fresh Cement Pastes with Polycarboxylate Superplasticizer

Variations of Yield Stress of Fresh Cement Pastes in the Presence of Superplasticizer Highlighted by A Hydration Index

Critical Features of Microstructure Development of Early-Age Cement Paste Revealed by Non-Contact Electrical Resistivity Measurement

Rheo-viscoelastic Behavior and Viscosity Prediction of Calcium Sulphoaluminate Modified Portland Cement Pastes

Study on the rheological properties of Portland cement pastes with polycarboxylate superplasticizers

Morphological Effect of C–S–H Gel on the Elastic Behaviour of Early-Age Cement-Based Materials

Rheology and Yield Stress Evolution of Highly Flowable Cementitious Grouting Materials: Mechanisms and Modeling

Simple Three-Step Analytical Scheme for Prediction of Elastic Moduli of Hardened Cement Paste

Influence of flexible fibers on the yield stress of fresh cement pastes and mortars

In-situ Measurement of Viscoelastic Properties of Fresh Cement Paste by a Microrheology Analyzer

Effect of Alkali Content in Cement on the Fluidity and Structural Build-Up of Plasticized Cement Pastes

Strain-rate Sensitivity of Cement Paste by Microindentation Continuous Stiffness Measurement: Implication to Isotache Approach for Creep Modeling

Assessing strain rate sensitivity of cement paste at the micro-scale through micro-cantilever testing

Effects of water and temperature variations on deformation of limestone aggregates, cement paste, mortar and High Performance Concrete (HPC)

Rheology of Fresh Cement Pastes Containing Polymer Nanoparticles

Effects of Water-to-cement Ratio and Curing Age on Microscopic Creep and Creep Recovery of Hardened Cement Pastes by Microindentation

Clarifying the Deformation Restriction of Unhydrated Phase in Cement Paste to Its Autogenous Shrinkage