Abstract:The large extensional viscosity of dilute polymer solutions has been shown to dramatically delay the breakup of jets into drops. For low shear viscosity solutions, the jet breakup is initially governed by a balance of inertial and capillary stresses before transitioning to a balance of viscoelastic and capillary stresses at later times. This transition occurs at a critical time when the radius decay dynamics shift from a 2/3 power law to an exponential decay as the increasing deformation rate imposed on the fluid filament results in large molecular deformations and rapid crossover into the elasto-capillary regime. By experimental fits of the elasto-capillary thinning diameter data, a relaxation time of less than 100 μs has been successfully measured. In this paper, we show that, with a better understanding of the transition from the inertia-capillary to the elasto-capillary breakup regime, relaxation times close to 10 μs can be measured with the relaxation time resolution limited only by the frame rate and spatial resolution of the high speed camera. In this paper, the dynamics of drop formation and pinch-off are presented using dripping onto substrate capillary breakup extensional rheometry (CaBER-DoS) for a series of dilute solutions of polyethylene oxide (PEO) in water and in a viscosified water and glycerin mixture. Four different molecular weights between 100 k and 1 M g/mol were studied with varying solution viscosities between 1 and 22 mPa s and at concentrations between 0.004 and 0.5 times the overlap concentration, c*. The dependence of the relaxation time and extensional viscosity on these varying parameters was studied and compared to the predictions of dilute solution theory while simultaneously searching for the lower limit in solution elasticity that can be detected. For PEO in water, this limit was found to be a fluid with a relaxation time of roughly 20 μs. These results confirm that CaBER-DoS can be a powerful technique characterizing the rheology of a notoriously difficult material to quantify, namely, low viscosity inkjet printer inks.

Hemline breakup of gel drops subjected to a continuous air flow

Parallel Breakup of Polymer Drops under Simple Shear

Erosion and breakup of polymer drops under simple shear in high viscosity ratio systems

Sheet formation during drop deformation and breakup in polyethylene/polycarbonate systems sheared between parallel plates

Quantifying the Spatial-Temporal Evolution of Rim/Ligament in Drop Breakup Via Digital In-Line Holography

Characterization of the Bag Breakup of Liquid Drop Using High-Speed Digital In-Line Holography

An Experimental Investigation on the Secondary Breakup of Carboxymethyl Cellulose Droplets

Effect of Pre-Made Compatibilizer and Reactive Polymers on Polymer Drop Breakup

A Comparative Study on the Breakup of Newtonian and Viscoelastic Liquid Films

Necking and failure of a colloidal gel arm: signatures of yielding on different length scales

Linear instability analysis of a shear thinning gelled jet with yield stress in coaxial atomization

Secondary breakup of shear thickening suspension drop

Deformation and breakup behaviors of a Giesekus viscoelastic droplet in Newtonian shear flow

Droplet deformation and breakup in shear-thinning viscoelastic fluid under simple shear flow

Direct observation on the surface fracture of ultrathin film double-network hydrogels

High Fracture Efficiency and Stress Concentration Phenomenon for Microgel-Reinforced Hydrogels Based on Double-Network Principle

Study on aerodynamic breakup of non-Newtonian liquid droplets and the distribution characteristics of their sub-droplets

Critical breakup transition characteristics of thin viscose liquid film at spinning disk rim

Bag breakup of low viscosity drops in the presence of a continuous air jet

Yielding in colloidal gels: from local structure to meso-scale strand breakage and macroscopic failure

Drop breakup dynamics of dilute polymer solutions: Effect of molecular weight, concentration, and viscosity