An Experimental Study on the Flash Boiling Characteristics of Liquid Ammonia Spray in a Constant Volume Chamber under High Injection Pressure

Haibin He,Jie Wu,Lei Wang,Hua Lou,Songfeng Li,Lvmeng Huang,Zhanming Chen

DOI: https://doi.org/10.3390/pr12061076

IF: 3.5

2024-05-25

Processes

Abstract:The spray characteristics of liquid ammonia under various ambient pressures and temperatures were analyzed in a constant volume chamber to cover a wide range of superheat degrees. The injection pressure was set as 70 and 80 MPa with ambient pressure ranging from 0.2 to 4 MPa. The ambient temperature was 500 K. The results showed that the higher the injection pressure, the greater the kinetic energy obtained. The droplet fragmentation was enhanced, and the phenomenon of gradual separation of the gas–liquid region occurred with increasing injection pressure. Under flash boiling spray conditions, the spray developed faster than non-flash boiling and transition flash boiling spray under the same injection pressure. In addition, the flash boiling spray tip penetration of the gas and liquid increased more than that of cold spray, and the fluctuation of the late stage of the injection was relatively large. Therefore, the injection pressure has a greater effect on the spray tip penetration of flash boiling spray. Moreover, ambient pressure greatly influences the flare flash boiling spray. The spray resistance phenomenon was found during the spray development in the flare flash boiling condition. With the increase in ambient pressure, the spray tip penetration of flash boiling spray decreases due to the reduction in the pressure difference inside and outside the spray hole and the restriction of ambient gas. Meanwhile, owing to the low ambient pressure and ambient density, the liquid penetration in the initial phase of the flare flash boiling spray will be abnormally shorter than that of the non-flash boiling spray.

engineering, chemical

What problem does this paper attempt to address?

### What problem does this paper attempt to solve?

This paper primarily explores the experimental study of flash evaporation characteristics of liquid ammonia spray under high-pressure injection conditions. Specifically:

1. **Background and Challenges**:
- Liquid ammonia, as a carbon-free fuel, has the advantage of zero carbon emissions in internal combustion engines, but it has poor combustion characteristics, including low calorific value, low laminar speed, and low flammability.
- To overcome these obstacles, researchers have considered methods such as hydrogen assistance and pre-combustion to improve the application of ammonia fuel in internal combustion engines.

2. **Research Objectives**:
- To study the flash evaporation characteristics of liquid ammonia spray under high injection pressures (70 and 80 MPa) at different ambient pressures (0.2 to 4 MPa) and temperatures (500 K).
- To explore the spray development characteristics under different flash evaporation regions (non-flash evaporation spray, transitional flash evaporation spray, and flame flash evaporation spray).

3. **Specific Issues**:
- The impact of high-pressure injection on liquid ammonia spray, including changes in spray velocity, gas-liquid separation phenomena, and spray penetration distance.
- The effect of different ambient pressures on the flash evaporation characteristics of liquid ammonia spray, particularly how to improve spray characteristics under high-pressure conditions to enhance combustion efficiency.

Through these studies, the paper aims to provide data support for the direct injection application of liquid ammonia in internal combustion engines and to provide a theoretical basis for developing related simulation models.