Abstract:The reliable measurement of pressures on low-rise buildings in the atmospheric boundary layer (ABL) flow remains a challenge, as has been shown by the large discrepancies among results obtained in different wind tunnel facilities or even in the same wind tunnel. Two major causes of the discrepancies are the difficulty of simulating large-scale, low-frequency turbulent fluctuations uniformly across laboratories and the small scale of models in typical civil engineering wind tunnels. To address these issues, it was proposed that a simplified flow be used in laboratory simulations, rather than a conventional ABL flow. In the simplified flow the reference mean wind speed is larger than the mean wind speed of the ABL flow, and the low-frequency fluctuations present in the ABL flow are suppressed; that is, the peak energy of the missing low-frequency fluctuations is supplied in the simplified flow by the increment in the mean wind speed, which may be regarded as a flow fluctuation with zero frequency. High-frequency turbulent fluctuations, which typically affect flow reattachment, are approximately the same in the ABL and the simplified flow. Because, over small distances, low-frequency fluctuations are highly coherent spatially for small low-rise buildings with dimensions of up to approximately 20 m (e.g., single-family residential homes), the peak aerodynamic effects of the two flows may be hypothesized to be approximately the same. Preliminary experimental results obtained in University of Western Ontario’s ABL wind tunnel facility and Florida International University’s small-scale Wall of Wind facility are shown to support this hypothesis. The use of the proposed simplified flow is currently being tested by the authors for application to computational wind engineering (CWE) applications. Such use eliminates the need to simulate the lower frequency fluctuations of the boundary layer flow and thus makes it possible to achieve practical CWE calculations, and it is advantageous in experiments from the points of view of measurement accuracy, model scaling, repeatability of the simulations, and computational efficiency.

Predicting far-lee wind flow characteristics behind a 2D wedge-shaped obstacle: Experiments, numerical simulations and empirical equations

AN EXTENDED K-Ε MODEL FOR NUMERICAL SIMULATION OF WIND FLOW AROUND BUILDINGS

An extended kappa-epsilon model for numerical simulation of wind flow around buildings

Numerical Simulation of Free Surface Flow over Solid Obstacles Based on High-Order Accurate Scheme

The numerical simulation of separated flow at large attack angles for a wind turbine airfoil

Numerical Simulation of Separated Flows over Slender Body at High-Angle-of-attack with K-Ε Model Comforming Realizability

A calculation method for modeling the flow characteristics of the wind turbine airfoil with leading-edge protuberances

Simplified Wind Flow Model for the Estimation of Aerodynamic Effects on Small Structures

Experimental and Numerical Modelling of Flow over Complex Terrain: The Bolund Hill

3-D LES numerical simulation researches on wind flows interfered by rough waves

An Information Exchange Framework Between Physical Modeling and Numerical Simulation to Advance Tropical Cyclone Boundary Layer Predictions

An advanced three-dimensional analytical model for wind turbine near and far wake predictions

Improved K-E Two-Equation Turbulence Model For Canopy Flow

Validation and application of pressure-driven RANS approach for wind parameter predictions in mountainous terrain

The wind-shade roughness model for turbulent wall-bounded flows

Two-Dimensional Large-Eddy Simulation of Flow Past a Wind Turbine Airfoil in Deep Fall

Parameterization of Sheared Convective Entrainment in the First-Order Jump Model: Evaluation Through Large-Eddy Simulation

Numerical Evaluation of the Scale Problem on the Wind Flow of A Windbreak

Numerical simulation and model prediction of complex wind-turbine wakes

Simulation of Canopy Flows Using K-Ε Two-Equation Turbulence Model with Source/sink Terms

Numerical Investigation of Supersonic Flow over a Wedge by Solving 2D Euler Equations Utilizing the Steger–Warming Flux Vector Splitting (FVS) Scheme