Magnetic Shielding Effectiveness of Iron-Based Amorphous Alloys and Nanocrystalline Composites

A. Chrobak,A. Kaleta,P. Kwapulinski,M. Kubisztal,G. Haneczok
DOI: https://doi.org/10.1109/tmag.2011.2172587
IF: 1.848
2012-04-01
IEEE Transactions on Magnetics
Abstract:This paper refers to magnetic field shielding effectiveness Sh of the selected iron-based amorphous alloys and some magnetic composites. The measurement conditions were chosen regarding the potential sources such as energetic lines or electric devices. As it was shown, the shields made of amorphous and optimized (in amorphous phase) melt spun ribbons can be applied as highly efficient and flexible shields. In the group of the tested alloys, the highest SH reveal (at H = 110 A/m and f = 55 Hz): Fe84 Cr2 B14 (95%) and optimized Fe72 Co10 Nb6 B14 (97%) and Fe80 Nb6 B14 (92%). In the case of the tested composites, a significant decrease of SH was observed. The shielding effectiveness decreases with decreasing size of magnetic addition due to breaking magnetic flux circuit and dipolar interactions between particles. For the composite with magnetic flakes of 4 mm in diameter SH is about 60%; therefore, it can be applied as coatings in order to fulfill human protective standards. For the composites with micro and nano-sized magnetic powder SH does not depend of the composition which suggests that a response to a magnetic field is fully influenced by the demagnetization effect.
engineering, electrical & electronic,physics, applied
What problem does this paper attempt to address?