Abstract:This paper addresses issues of the synergetic dynamic effect of capillary force on the longitudinal impregnation driven by external pressures, especially under vacuum assistance. An apparatus was designed to detect the axial infiltration along unidirectional fiber bundles which were all aligned closely to give a representation of micro-flow channel of inner fiber tows. The external driving pressures were controlled sufficiently low, 20–60kPa, on the order of capillary pressures. Based on the analysis of infiltration velocities under different external pressures, dynamic capillary pressures can be determined experimentally. The results showed that capillary pressures, the most important force of microscopic flow through inner fiber yarns, acted as a drag force on the infiltration flow for vacuum assisted penetration into unidirectional fiber bundles. This unique drag effect is very different from traditional unsaturated infiltration, different from the compressed air driving permeation and the theoretical calculated data in this paper. Moreover, values and even signs of the dynamic capillary pressures varied with the fiber fraction of the assemblies as well as the fluid types. Further analysis demonstrated that the function of capillary pressure was closely related to the capillary number (Ca), acting as drag force when Ca larger than a critical value, and as a promotive force with smaller Ca. Consequently, unsaturated permeabilities of the unidirectional fiber bundles were estimated by taking consideration of both dynamic and quasi-static capillary pressures.

Unsaturated out-of-plane permeability measured with three-dimensional flow monitoring by etched optical fiber sensors

Infiltration monitoring using carbon nanotube buckypaper for the characterization of out‐of‐plane unsaturated permeability

Woven Geotextile Permeability under Uniaxial and Laterally Constrained Conditions

Permeability Prediction in Nonwoven Geotextiles Using Mathematical Modeling and Numerical Simulation

Numerical prediction strategy of fabric in‐plane permeability considering realistic inter‐ and intra‐tow geometry

Sensor Fusion for Simultaneous Estimation of In-Plane Permeability and Porosity of Fiber Reinforcement in Resin Transfer Molding

Investigation of Transport Property of Fibrous Media: 3D Virtual Modeling and Permeability Calculation

Gas transport in fibrous media: Application to in-plane permeability measurement using transient flow

Bio-inspired flow rate sensor based on optical microfiber embedded soft film

On the design of test molds based on unidirectional saturated flows to measure transverse permeability in liquid composite molding

Permeability analysis of unidirectional fiber assembly under different testing conditions

A novel approach based on stress-impedance effect to assess the interfacial properties in fiber-reinforced composites

Permeability measurement of a 3D-printed AlSi10Mg porous medium: comparisons between first results with different experimental and numerical techniques

Embedding Piezoresistive Pressure Sensors to Obtain Online Pressure Profiles Inside Fiber Composite Laminates

Model Prediction and Experimental Validation of Transverse Permeability of Large-Tow Carbon Fiber Composites

Multidirectional permeability simulation for fiber network based on the pore structure 3D characterization by CT scanning

Dynamic capillary impact on longitudinal micro-flow in vacuum assisted impregnation and the unsaturated permeability of inner fiber tows

Optical measurement of voids in situ during infusion of carbon reinforcements

Permeability testing and mechanism analysis of aramid fiber hybrid fabrics

Estimating the interfacial permeability for flow into a poroelastic medium

Evaluation of through-thickness permeability and the capillary effect in vacuum assisted liquid molding process