Abstract:During the production of fiber-reinforced plastics using resin transfer molding (RTM), various characteristic defects and flaws can occur, such as fiber displacement and fiber waviness. Particularly in high-pressure RTM (HP-RTM), fiber misalignments are generated during infiltration by local peaks in the flow rate, leading to a significant reduction in the mechanical properties. To minimize or avoid this effect, the manufacturing process must be well controlled. Simulative approaches allow for a basic design of the mold filling process; however, due to the high number of influencing variables, the real behavior cannot be exactly reproduced. The focus of this work is on flow front monitoring in an HP-RTM mold using phased array ultrasonic testing. By using an established non-destructive testing instrument, the effort required for integration into the manufacturing process can be significantly reduced. For this purpose, investigations were carried out during the production of test specimens composed of glass fiber-reinforced polyurethane resin. Specifically, a phased array ultrasonic probe was used to record individual line scans over the form filling time. Taking into account the specifications of the probe used in these experiments, an area of 48.45 mm was inspected with a spatial resolution of 0.85 mm derived from the pitch. Due to the aperture that had to be applied to improve the signal-to-noise ratio, an averaging of the measured values similar to a moving average over a window of 6.8 mm had to be considered. By varying the orientation of the phased array probe and therefore the orientation of the line scans, it is possible to determine the local flow velocities of the matrix system during mold filling. Furthermore, process simulation studies with locally varying fiber volume contents were carried out. Despite the locally limited measuring range of the monitoring method presented, conclusions about the global flow behavior in a large mold can be drawn by comparing the experimentally determined results with the process simulation studies. The agreement between the measurement and simulation was thus improved by around 70%.

On the design of test molds based on unidirectional saturated flows to measure transverse permeability in liquid composite molding

Numerical evaluation of the transverse permeability determination experiment

Simulation of Fiber Reinforced Composite Materials Mold Filling Process and Mechanical Properties Analysis

Dynamic Simulation of Fiber Orientation in Mold Filling Process in a Complex Cavity

Characterization of 3D fiber preform permeability tensor in radial flow using an inverse algorithm based on sensors and simulation

Statistical characterization of fiber permeability for composite manufacturing

A Simple Method for the Measurement of Compaction and Corresponding Transverse Permeability of Composite Prepregs

The Research Development of Mechanical Testing Methods for Liquid Composites

Visualization And Quantification Of Forced In-Plane Flow Through Deformed Porous Media

Pore-scale modeling of wettability effects on infiltration behavior in liquid composite molding

Unsaturated Flow Behavior in Double-Scale Porous Reinforcement for Liquid Composite Molding Processes

Modeling and Simulation of Fiber Reinforced Polymer Mold Filling Process by Level Set Method

Investigation of Transport Property of Fibrous Media: 3D Virtual Modeling and Permeability Calculation

Numerical prediction strategy of fabric in‐plane permeability considering realistic inter‐ and intra‐tow geometry

3D actual microstructure-based modeling of non-isothermal infiltration behavior and void formation in liquid composite molding

A methodology for using long-period gratings and mold-filling simulations to minimize the intrusiveness of flow sensors in liquid composite molding

Sensor Fusion for Simultaneous Estimation of In-Plane Permeability and Porosity of Fiber Reinforcement in Resin Transfer Molding

Evaluation of through-thickness permeability and the capillary effect in vacuum assisted liquid molding process

An approach to couple mold design and on-line control to manufacture complex composite parts by resin transfer molding

Flow Front Monitoring in High-Pressure Resin Transfer Molding Using Phased Array Ultrasonic Testing to Optimize Mold Filling Simulations

New set-up for measurement of permeability properties of fibrous reinforcements for RTM