Abstract:This paper addresses issues of the synergetic dynamic effect of capillary force on the longitudinal impregnation driven by external pressures, especially under vacuum assistance. An apparatus was designed to detect the axial infiltration along unidirectional fiber bundles which were all aligned closely to give a representation of micro-flow channel of inner fiber tows. The external driving pressures were controlled sufficiently low, 20–60kPa, on the order of capillary pressures. Based on the analysis of infiltration velocities under different external pressures, dynamic capillary pressures can be determined experimentally. The results showed that capillary pressures, the most important force of microscopic flow through inner fiber yarns, acted as a drag force on the infiltration flow for vacuum assisted penetration into unidirectional fiber bundles. This unique drag effect is very different from traditional unsaturated infiltration, different from the compressed air driving permeation and the theoretical calculated data in this paper. Moreover, values and even signs of the dynamic capillary pressures varied with the fiber fraction of the assemblies as well as the fluid types. Further analysis demonstrated that the function of capillary pressure was closely related to the capillary number (Ca), acting as drag force when Ca larger than a critical value, and as a promotive force with smaller Ca. Consequently, unsaturated permeabilities of the unidirectional fiber bundles were estimated by taking consideration of both dynamic and quasi-static capillary pressures.

Infiltration monitoring using carbon nanotube buckypaper for the characterization of out‐of‐plane unsaturated permeability

Unsaturated out-of-plane permeability measured with three-dimensional flow monitoring by etched optical fiber sensors

Permeability Prediction in Nonwoven Geotextiles Using Mathematical Modeling and Numerical Simulation

Woven Geotextile Permeability under Uniaxial and Laterally Constrained Conditions

A pressurized filtration technique for fabricating carbon nanotube buckypaper: Structure, mechanical and conductive properties

Single Carbon Fiber/Acid-Treated CNT-Epoxy Composites by Electro- Micromechanical Technique and Wettability Test for Dispersion and Self-Sensing

A New Electrical Resistance Measurement Method of Carbon Fiber-Reinforced Polymer Tubes Based on C⁴D Technique

Water Transport Phenomena Through Membranes Consisting of Vertically-Aligned Double-Walled Carbon Nanotube Array

Multidirectional permeability simulation for fiber network based on the pore structure 3D characterization by CT scanning

Role of Carbon Nanotube Wetting Transparency in Rapid Water Transport for a Nanopore Membrane.

Measurement of the Rate of Water Translocation Through Carbon Nanotubes.

Numerical prediction strategy of fabric in‐plane permeability considering realistic inter‐ and intra‐tow geometry

Permeability analysis of unidirectional fiber assembly under different testing conditions

A Single Glass Fiber with Ultrathin Layer of Carbon Nanotube Networks Beneficial to In-Situ Monitoring of Polymer Properties in Composite Interphases

Sensor Fusion for Simultaneous Estimation of In-Plane Permeability and Porosity of Fiber Reinforcement in Resin Transfer Molding

Dynamic capillary impact on longitudinal micro-flow in vacuum assisted impregnation and the unsaturated permeability of inner fiber tows

Glass Fibers with Carbon Nanotube Networks As Multifunctional Sensors

A New Route to Enhance the Packing Density of Buckypaper for Superior Piezoresistive Sensor Characteristics

A Sensitivity Enhanced Gas Sensor Based on Carbon Nanotubes Around Microfiber

Gas transport in fibrous media: Application to in-plane permeability measurement using transient flow

Permeability of needle-punched nonwoven geotextiles subjected to uniaxial tensile strains