Abstract:To find an effective correlation between the preparation process and the application performance of symmetric supercapacitors, the relationship between the structural characteristics of biomass porous carbon and the electrochemical performances of supercapacitors was studied. Based on a response surface experimental design, the pore structure of biochar produced by the microwave pyrolysis of sargassum was adjusted through the collaborative optimization of key parameters, and graded sargassum porous carbon (SPC) with different pore characteristics was successfully prepared. Three representative samples, SPC−1, SPC−2, and SPC−3, were selected by systematically exploring the effects of the specific surface area (SSA), pore volume (Vtotal), and pore size distribution on the electrochemical performances. The SSA and V total values of SPC−1 were 1500.50 m 2 g −1 and 1.0513 cm 3 g −1 , respectively. The large number of micropores provided space for electronic storage, allowing it to have an excellent electronic storage capacity. The SSA of SPC−2 was 2019.90 m 2 g −1 , and Vtotal was 1.2241 cm 3 g −1 . The rich micropores resulted in a good charge–discharge rate. The SSA of SPC−3 was as high as 2103.20 m 2 g −1 , and Vtotal was 1.4756 cm 3 g −1 . The micron−level mesopores between the SPC−3 carbon skeletons acted as ion buffer reservoirs to shorten the ion diffusion distance and produce excellent rate performances. Subsequently, the morphology and surface properties of porous carbon samples were characterized. The study revealed that hierarchical porous carbon materials with excellent properties must achieve a balance of the microstructure and surface properties and their influence on the electrochemistry. A higher degree of graphitization could bring about a high pore regularity, thereby optimizing the ion transport kinetics. Heteroatoms could increase redox active surface sites and provide additional pseudocapacitance, but the resulting defect structure formed a large number of pores with high edge roughness in the carbon material, which had a certain negative impact on the capacity properties of the materials. The above findings can provide technical support and a theoretical basis for controlling the pore networks and directionally optimizing the performances of supercapacitors by adjusting the pore structure of biochar.

Preparation of nitrogen-rich porous carbon by microwave-assisted two-step co-pyrolysis of kapok wood and chlorella vulgaris

Green Synthesis of Nitrogen-doped Porous Carbon Derived from Rice Straw for High-performance Supercapacitor Application

Low-cost pyrolysis of biomass-derived nitrogen-doped porous carbon: Chlorella vulgaris replaces melamine as a nitrogen source

Chitosan-derived large surface area porous carbon via microphase separation engineering of pore-regulation and nitrogen-doping coupling for high-performance supercapacitors

A green strategy to prepare nitrogen-oxygen co-doped porous carbons from macadamia nut shells for post-combustion CO2 capture and supercapacitors

Green Conversion of Bamboo Chips into High-Performance Phenol Adsorbent and Supercapacitor Electrodes by Simultaneous Activation and Nitrogen Doping

Preparation of Porous Biochar and Its Application in Supercapacitors

One-step carbonization strategy of freeze-dried chitosan to prepare Nitrogen-Oxygen co-doped porous carbon supercapacitors with ultra-large specific surface area

A Novel Approach for Preparing In-Situ Nitrogen Doped Carbon Via Pyrolysis of Bean Pulp for Supercapacitors

Preparation of ultrafine microporous nitrogen self-doped chitosan (CS) carbon aerogel based on a Zn-Zn system for high-performance supercapacitors

ZnCl2-KOH modulation of biomass-derived porous carbon for supercapacitors

In Situ, Nitrogen-Doped Porous Carbon Derived from Mixed Biomass as Ultra-High-Performance Supercapacitor

Green synthesis of nitrogen self-doped porous carbons from waste garlic peels for high-performance supercapacitor applications

Two-step pyrolysis of mango branch for the preparation of B/N/O co-doped porous carbon materials

Ultrahigh yield of nitrogen doped porous carbon from biomass waste for supercapacitor

Preparation of biomass-based N, P, and S co-doped porous carbon with high mesoporosity based on the synergistic effect of NaOH/thiourea and melamine phosphate and its application in high performance supercapacitors

Preparation of nitrogen-doped porous carbon from pyrolysis of light bio-oil pretreated poplar powder and its electrochemical performance

Green synthesis of N, O, P co-doped porous carbon from co-pyrolysis of bamboo and ammonium polyphosphate for supercapacitors

Silicate-assisted activation of biomass towards N-doped porous carbon sheets for supercapacitors

Preparation of hierarchical porous carbon by pyrolyzing sargassum under microwave: The internal connection between structure−oriented regulation and performance optimization of supercapacitors

Deep insight into the pore size distribution of N-doped porous carbon materials on electrochemical energy storage and CO2 sorption