Abstract:Introduction: Permethrin is a common pesticide spray-applied to civilian clothing and military uniforms for protection against biting arthropods in an effort to reduce risks to arthropod-borne diseases. During mass clothing spray events, exposure is possible through the dermal, inhalation, and ingestion routes. The potentially exposed population during a spray event includes the pesticide applicator(s) and working party (personnel who handle clothing/uniforms by positioning on the ground, flipping, and removing after spraying is complete). Previous investigation is limited regarding permethrin exposure via multiple routes of entry. Additionally, most exposure assessments are limited to pesticide applicators rather than working party that support applicator personnel. The purpose of this investigation was to conduct a multi-route exposure assessment for all personnel normally participating in mass permethrin military uniform treatments. Materials and methods: The protocol and Informed Consent Document were approved by the Uniformed Services University of the Health Sciences (USUHS) Institutional Review Board (IRB) before fieldwork initiation (IRB number: USUHS.2019-032). Sampling occurred during routine spray events performed by 14 U.S. Navy personnel (3 applicators and 11 working party) over 2 days. Personal exposures were measured with dermal sampling, and airborne concentrations were measured with area air sampling. Permethrin area air sampling and analysis were conducted using OSHA Versatile Sampler-2 sampling media (n = 36). Dermal exposure was measured using dosimeter gloves (n = 26) and a dermal patch (n = 26) worn by study participants. Results: All air samples were reported below the 0.4 µg limit of quantification. Glove sample results ranged from 45 to 120,000 µg and patch results ranged from 0.57 to 45 µg. A repeated-measures ANOVA showed non-statistically significant differences in dermal concentrations (P-value = .8340) between the applicators and working party in patches and gloves. Conclusions: Results suggest dermal contact is the primary route of exposure compared to inhalation when mass spraying clothing with permethrin. Similar dermal exposures between these two occupations may necessitate reconsidering risk assessment procedures, training and personal protective equipment (PPE) requirements for mass spray uniform treatments. Specifically, while PPE requirements for applicators are highly regulated by the Armed Forces Pest Management Board and include items such as Tyvek suits, chemical protective gloves, and air-purifying respirators, PPE was not regulated for working party personnel before this investigation.

A field sampling and analysis protocol for assessing occupational exposure and risk from military munition storage magazines

Improving post-detonation energetics residues estimations for the Life Cycle Environmental Assessment process for munitions

Determination of Airborne Release Fractions from Loose Powder Contamination Under Impact Stress

Assessment of Dermal and Inhalation Exposure to Permethrin During Field Treatment of Military Uniforms

Particle Morphology and Elemental Analysis of Lung Tissue from Post-9/11 Military Personnel with Biopsy-Proven Lung Disease

Method development for on-site monitoring of volatile organic compounds via portable TD-GC-MS: evaluation of the analytical performances of HAPSITE® ER instrumentation and thermal desorption sampling media

Quantification and health risk assessment of heavy metals in residual floor dust at an indoor firing range: A case study in Trinidad, WI

Increased impact sensitivity in ageing high explosives; analysis of Amatol extracted from explosive remnants of war

Determination of Energetic Compounds in Ammunition Contaminated Soil by Accelerated Solvent Extraction (ASE) and Gas Chromatography – Microelectron Capture Detection (Gc-Μecd)

Comparison of methods for personal sampling of inhalable and total lead and cadmium-containing aerosols in a primary lead smelter

Use of Routine Environmental Monitoring Data to Establish a Dose-based Compliance System for a Low-level Radioactive Waste Disposal Site

Evaluation of SNOLAB background mitigation procedures through the use of an ICP-MS based dust monitoring methodology

Database of in-plume emission factors from open demilitarization of military ordnance

Characterizing metals in particulate pollution in communities at the fenceline of heavy industry: Combining mobile monitoring and size-resolved filter measurements

Release of Munitions Constituents in Aquatic Environments Under Realistic Scenarios and Validation of Polar Organic Chemical Integrative Samplers for Monitoring

Sorbent Film-Coated Passive Samplers for Explosives Vapour Detection Part B: Deployment in Semi-Operational Environments and Alternative Applications

Particle analysis of surgical lung biopsies from deployed and non-deployed US service members during the Global War on Terrorism

Use of electron microscopy to determine presence of coal dust in a neighborhood bordering an open-air coal terminal in Curtis Bay, Baltimore, Maryland, USA

Micro-extraction method for the analysis of flame retardants in dust collected from air filters from HVAC systems

In Situ Lung Dust Analysis by Automated Field Emission Scanning Electron Microscopy With Energy Dispersive X-ray Spectroscopy: A Method for Assessing Inorganic Particles in Lung Tissue From Coal Miners

Spatial Distribution of Heavy Metal Contamination in Soils of Fallujah, Iraq