Influence of preparation method on Ni/SiO2 catalyst for selective hydrogenation of succinic anhydride to γ-butyrolactone

An Bao,Chenju Chen,Huiqin Tao,Huirong Lai,Baigang Yang,Chun lei Zhang
DOI: https://doi.org/10.1039/d4cy00097h
IF: 6.177
2024-06-06
Catalysis Science & Technology
Abstract:Selective hydrogenation of succinic anhydride (SAA) to γ-butyrolactone (GBL) is a novel and efficient route to synthesis GBL. Highly efficient Ni/SiO2 catalysts with large specific surface area were prepared with three different methods and applied for selective hydrogenation of SAA to GBL. The preparation methods significantly affected the Ni species dispersion, surface properties and catalytic properties of Ni/SiO2 catalysts. Ni/SiO2 prepared with ammonia evaporation method (Ni/SiO2-AE) had the largest specific surface area of 291 m2/g and smallest Ni crystallite size of 8 nm, but the aggregation of Ni species during the reaction would result in decline of catalytic activity. Ni/SiO2 prepared with oxalic acid precipitation method (Ni/SiO2-OP) and sodium carbonate precipitation (Ni/SiO2-SP) showed similar textural properties. However, the strong surface acidity of Ni/SiO2-OP would facilitate the formation of tetrahydrofuran (THF). XPS results indicated that largest Ni0/Ni2+ ratio was observed in Ni/SiO2-SP, leading to the lowest THF selectivity and highest GBL selectivity. Under the conditions of 185 oC, 3.0 MPa, WHSV = 0.2 h-1, molar ratio of H2/SAA = 50, Ni/SiO2-SP showed a SAA conversion of 89.7% with a GBL selectivity of 96.2% and excellent stability during the 50-h test.
chemistry, physical
What problem does this paper attempt to address?