Using the Sensible Heat Flux Eddy Covariance-Based Exchange Coefficient to Calculate Latent Heat Flux from Moisture Mean Gradients Over Snow

Sergi González-Herrero,Armin Sigmund,Michael Haugeneder,Océane Hames,Hendrik Huwald,Joel Fiddes,Michael Lehning

DOI: https://doi.org/10.1007/s10546-024-00864-y

2024-05-08

Boundary-Layer Meteorology

Abstract:In absence of the high-frequency measurements of wind components, sonic temperature and water vapour required by the eddy covariance (EC) method, Monin–Obukhov similarity theory (MOST) is often used to calculate heat fluxes. However, MOST requires assumptions of stability corrections and roughness lengths. In most environments and weather situations, roughness length and stability corrections have high uncertainty. Here, we revisit the modified Bowen-ratio method, which we call C-method, to calculate the latent heat flux over snow. In the absence of high-frequency water vapour measurements, we use sonic anemometer data, which have become much more standard. This method uses the exchange coefficient for sensible heat flux to estimate latent-heat flux. Theory predicts the two exchange coefficients to be equal and the method avoids assuming roughness lengths and stability corrections. We apply this method to two datasets from high mountain (Alps) and polar (Antarctica) environments and compare it with MOST and the three-layer model (3LM). We show that roughness length has a great impact on heat fluxes calculated using MOST and that different calculation methods over snow lead to very different results. Instead, the 3LM leads to good results, in part due to the fact that it avoids roughness length assumptions to calculate heat fluxes. The C-method presented performs overall better or comparable to established MOST with different stability corrections and provides results comparable to the direct EC method. An application of this method is provided for a new station installed in the Pamir mountains.

meteorology & atmospheric sciences

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is how to estimate the latent heat flux on the snow surface by using the exchange coefficient of the eddy covariance method of sensible heat flux in the absence of high - frequency wind speed, sonic temperature and water vapor measurement data. Specifically, the paper re - examines an improved Bowen ratio method, called the C - method, for estimating latent heat flux using ultrasonic anemometer data in the absence of high - frequency water vapor measurement data. This method avoids the need to assume roughness length and stability correction, thereby reducing uncertainty and error.

The paper points out that the traditional Monin - Obukhov similarity theory (MOST) needs to assume stability and roughness length when calculating heat flux, and these parameters have high uncertainty under most environmental and weather conditions. Therefore, the author proposes a new method, namely the C - method, to overcome these limitations and compares it with the existing MOST method and the three - layer model (3LM). The research shows that the C - method performs well or is comparable to the existing MOST method in alpine (the Alps) and polar (Antarctica) environments and can provide results comparable to the direct eddy covariance method.

In addition, the paper also shows the application of the C - method in a newly installed meteorological station in the Pamir Mountains, which is only equipped with an ultrasonic anemometer and no high - frequency humidity sensor. Through these measurement data, researchers can estimate the sublimation process without high - frequency humidity data.