Abstract:Regional sensible and latent heat fluxes are the key physical parameters of the meteorological, hydrological and ecological models. However it is very difficult to obtain these fluxes from conventional ground measurement. Using satellite remotely sensed data to retrieve these fluxes supplies one possible way to solve this problem. However, the gradient measurement is needed when calculating the fluxes are calculated, while the measurements from only one layer can be obtained from satellite. To solve this problem, many studies have been carried out. There are two main ways that can be seen: the physical model and empirical model. The physical models have two directions: the gradient model and the thermal inertia method. Gradient models combine the satellite remotely sensed data with the ground measurements, and use the difference of surface temperature and air temperature at reference height to calculate sensible heat flux. The latent heat flux is obtained as the residual. The thermal inertia method uses the response of soil to the absorption of solar radiation to calculate the sensible and latent heat flux. The empirical method calculates empirical regression between the measurements of the fluxes and the satellite remotely sensed data, and then extends this relationship to calculate the fluxes. Here the daily-average fluxes are often used. Four gradient models are reviewed, including one one-source model and three two-source models. When use the one-source model is used for to partly vegetation-covered surface, the difference of the air dynamic temperature and the thermal radioactive temperature hinds it usage. Two-source models can solve this problem. However, all the gradient models are sensitive to the error of the difference between the satellite retrieved surface temperature and the measurements of the air temperature. Another shortcoming of the gradient model is that they need to interpolate ground measurements, such as the air temperature and wind speed. These interpolations always are of low quality with unacceptable errors. The thermal inertia method calculates sensible and latent heat fluxes only using the satellite remotely sensed data, which will have a wider usage in the near future. However, up to today, this method only succeeded in the bare soil surface. More attention should be paid to it in the future. At last, the methods used to evaluate the accuracy of the retrieval of sensible and latent heat fluxes are reviewed.

Improving Computation of Sensible Heat Flux over a Water Surface Using the Variational Method

A Variational Method for Computation of Sensible Heat Flux over the Arctic Sea Ice

An Application of the Variational Method to Computation of Sensible Heat Flux over a Deciduous Forest

A variational method for estimating surface fluxes with mass conservation constraint

Water Flux Characterization Through Hydraulic Head and Temperature Data Assimilation: Numerical Modeling and Sandbox Experiments

Using the Sensible Heat Flux Eddy Covariance-Based Exchange Coefficient to Calculate Latent Heat Flux from Moisture Mean Gradients Over Snow

Flux-Variance Method for Latent Heat and Carbon Dioxide Fluxes in Unstable Conditions

Comparison Of Latent Heat Flux Estimates Over Australia

Estimation of Turbulent Fluxes Using the Flux-Variance Method over an Alpine Meadow Surface in the Eastern Tibetan Plateau

Improvement and Evaluation of the Latest Version of WRF-Lake at a Deep Riverine Reservoir

An Improved Heat Flux Theory and Mathematical Equation to Estimate Water Vapor Advection as an Alternative to Mechanistic Enhancement Factor

An evaluation of new satellite-derived latent and sensible heat fluxes with moored buoy data, OAFlux and NCEP2 reanalysis products

Mapping Regional Turbulent Heat Fluxes Via Assimilation of MODIS Land Surface Temperature Data into an Ensemble Kalman Smoother Framework

USING SATELLITE REMOTELY SENSED DATA TO RETRIEVE SENSIBLE AND LATENT HEAT FLUXES: A REVIEW

On the Extent of Applicability of Various Non-linear Similarity Functions for Computation of Surface Fluxes under Stable Conditions in Numerical Models

Ground heat flux determination based on near-surface soil hydro-thermodynamics

Simulation of the Surface Energy Flux and Thermal Stratification of Lake Taihu with Three 1-D Models

Representing the Heat-to-Moisture Transport Efficiency in Stable Conditions: an Extension of Two Different Approaches

Computing Surface Concentration Fluxes of Trace Gases from A Variational Method Using Measured Variance and Single-Level Concentration Data

A Temperature Prediction-Correction Method for Estimating Surface Soil Heat Flux from Soil Temperature and Moisture Data

Modeling Investigation of Thermal Circulations of a Large and Shallow Subtropical Lake