Abstract:Abstract The aim of the research work was to investigate the effect of superficial gas velocity and solids concentration on the critical agitator speed, gas hold-up and averaged residence time of gas bubbles in an agitated gas-solid-liquid system. Experimental studies were conducted in a vessel of the inner diameter of 0.634 m. Different high-speed impellers: Rushton and Smith turbines, A 315 and HE 3 impellers, were used for agitation. The measurements were conducted in systems with different physical parameters of the continuous phase. Liquid phases were: distilled water (coalescing system) or aqueous solutions of NaCl (non-coalescing systems). The experiments were carried out at five different values of solids concentration and gas flow rate. Experimental analysis of the conditions of gas bubbles dispersion and particles suspension in the vessel with a flat bottom and four standard baffles showed that both gas and solid phases strongly affected the critical agitation speed necessary to produce a three-phase system. On the basis of experimental studies, the critical agitator speed for all agitators working in the gas-solid-liquid systems was found. An increase of superficial gas velocity caused a significant increase of the gas hold-up in both coalescing and non-coalescing three-phase systems. The type of the impeller strongly affected the parameters considered in this work. Low values of the critical impeller speed together with the relatively short average gas bubbles residence time tR in three phase systems were characteristic for the A 315 impeller. Radial flow Rushton and Smith turbines are high-energy consuming impellers but they enable to maintain longer gas bubbles residence time and to obtain higher values of the gas hold-up in the three-phase systems. Empirical correlations were proposed for the critical agitator speed, mean specific energy dissipated and the gas hold-up prediction. Its parameters were fitted using experimental data.

Effects of superficial gas velocity on process dynamics in bioreactors

CFD-PBM Investigation on Droplet Size Distribution in a Liquid–Liquid Stirred Tank: Effect of Impeller Type

Computational Fluid Dynamics Simulation of Bubble Size and Local Gas Holdup in Stirred Vessel

Investigation of Gas–liquid Dispersion and Mass Transfer Performance of Wide-Viscosity-range Impellers in Water Solutions of Xanthan Gum

Modeling of gas–liquid mass transfer in a stirred tank bioreactor agitated by a Rushton turbine or a new pitched blade impeller

Experimental Study on Gas–liquid Dispersion and Mass Transfer in Shear-Thinning System with Coaxial Mixer

Gas–liquid mixing performance of a non‐Newtonian fluid in a multiple‐impeller agitated tank

The Influence of Impeller Combination on the Gas-Liquid Dispersion Performance of a Coaxial Mixer in Viscous Fluids

Numerical Analysis of Gas-Liquid Mixed Transport Process in a Multiphase Rotodynamic Pump

Experimental and Numerical Studies on Flow and Turbulence Characteristics of Impinging Stream Reactors with Dynamic Inlet Velocity Variation

Effect of Superficial Gas Velocity on Solid Behaviors in a Full-Loop CFB

Synergistic effects of vapor and gaseous cavitation and mass-transfer mechanism in a mechanical pump

The Effect of the Spargers Design on the Wastewater Treatment of Gas-Liquid Dispersion Process in a Stirred Tank

Characterizing the effect of impeller design in plant cell fermentations using CFD modeling

Solid suspension and gas dispersion in gas-solid-liquid agitated systems

Effect of the Gas Volume Fraction on the Pressure Load of the Multiphase Pump Blade

Gas-Liquid Mass Transfer Characteristics in a Rotating-Drum Bioreactor

Computational fluid dynamic simulation of gas-liquid flow in rotating packed bed: A review

Experimental Investigation on the Effect of Superficial Gas Velocity on Bubble Dynamics Properties of B Particles in Gas–solid Fluidized Bed Reactor Using Digital Image Analysis Technique

Effects of impeller types on gas-liquid mixing and oxygen mass transfer in aerated stirred reactors

Experimental study on gas-liquid flow regimes of coaxial mixers equipped with a Rushton/pitched blade turbine and anchor