Abstract:The broadening use of carbon-fiber reinforced plastics (CFRP) in various industries has raised safety concerns. To control the hazard, infrared thermography inspection techniques, capable of large-area scanning, instantaneous imaging, and completely non-contact detection, has been increasingly adopted to detect flaws inside CFRP structures. And in practical engineering, post-processing algorithms are required to eliminate noise and enhance defect detectability after initial inspection course. However, rapid updates of infrared camera bring high-resolution thermograms yet. Whereas classic algorithms have encountered data explosion problem which led to low efficiency and engineering infeasibility. Therefore, to promote the efficiency of postprocessing algorithms, we propose equal interval sampling (EIS) method to sample raw thermal data. Two CFRP laminates with embedded artificial Teflon inserts of different sizes at different depths are inspected by a laser infrared thermography system. The obtained raw thermal videos made up of 500 frame thermal images with 512 × 640 pixels were converted to 3D thermographic data. We apply EIS to sample the data by setting different intervals. And the sampled data are fed to classic post-processing algorithms, thermal signal reconstruction (TSR) and principal component analysis (PCA), which have prevailed in processing thermographic data. Regarding different intervals of EIS as variables, the processing efficiency, and the defect detection performance of EIS-TSR and EIS-PCA are studied. The results demonstrate that EIS-TSR method fails to promote processing speed and maintain the performance of defect detection at the same time. In contrast, the EIS-PCA method attains a remarkable efficiency and intact defect detectability simultaneously, manifesting its adequacy in engineering practice.

Novel Insights on Spatio-Temporal Analysis for Frequency Modulated Thermal Wave Imaging Using Principal Component Analysis on Glass Fibre Reinforced Polymer Material

Applications of Independent Component Thermography for Testing and Evaluation of Glass Fibre Reinforced Polymer Materials

An efficient data processing approach for frequency modulated thermal wave imaging for inspection of steel material

Time-Frequency Based Thermal Imaging: An Effective Tool for Quantitative Analysis

Thermal non‐destructive testing and evaluation for inspection of carbon fibre‐reinforced polymers

Defect Detection Capabilities of Pulse Compression Based Infrared Non-Destructive Testing and Evaluation

Thermographic Data Analysis for Defect Detection by Imposing Spatial Connectivity and Sparsity Constraints in Principal Component Thermography

Robust Principal Component Thermography for Defect Detection in Composites

Independent component thermography for non-destructive testing of defects in polymer composites

Analyzing efficiency of optical and THz infrared thermography in nondestructive testing of GFRPs by using the Tanimoto criterion

Exploratory Factor Analysis for Defect Identification with Active Thermography

Logarithmic Frequency Modulated Thermal Wave Imaging for Subsurface Analysis

3D photothermal reconstruction of subsurface defects in notched multidirectional CFRP laminates due to tensile fatigue loading

Comparative Analysis of Single- and Multiple-Frequency Thermal Wave Radar Imaging Inspection of Glass Fiber Reinforced Polymer (GFRP)

One-dimensional deep convolutional autoencoder active infrared thermography: Enhanced visualization of internal defects in FRP composites

Induction Infrared Thermography and Thermal-Wave-Radar Analysis for Imaging Inspection and Diagnosis of Blade Composites

Study on Equal Interval Sampling Method Promoting Efficiency of Post-Processing Algorithms for Infrared Thermography Inspecting Carbon-Fiber Reinforced Plastics Composites

Optimization of Thermal-Wave Radar Thermography by Transverse Heat Flow Suppression Technique for Accurate Defect Detection of CFRP Laminates

Non-linear frequency modulated thermal wave imaging for subsurface analysis

Image enhancement methods for inspection of planar and non-planar FRP structures using a noise-based microwave NDT inspection system