Abstract:Expiratory CO2 concentrations can directly reflect human physiological conditions, and their detection is highly important in the treatment and rehabilitation of critically ill patients. Existing respiratory gas analyzers suffer from large sizes and high power consumption due to the limitations of the internal CO2 sensors, which prevent them from being wearable to track active people. The internal and external interference and sensitivity limitations must be overcome to realize wearable respiratory monitoring applications for CO2 sensors. In this work, an ultra-compact CO2 sensor was developed by integrating a microelectromechanical system emitter and thermopile detectors with an optical gas chamber; the power consumption of the light source and ambient temperature of the thermally sensitive devices were reduced by heat transfer control; the time to reach stabilization of the sensor was shortened; the humidity resistance of the sensor was improved by a dual-channel design; the light loss of the sensor was compensated by improving the optical coupling efficiency, which was combined with the amplitude trimming network to equivalently improve the sensitivity of the sensor. The minimum size of the developed sensor was 12 mm × 6 mm × 4 mm, and the reading error was <4% of the reading from -20 °C to 50 °C. The minimum power consumption of the sensor was ~33 mW, and the response time and recovery time were 10 s (@1 Hz), and the sensor had good humidity resistance, stability, and repeatability. These results indicate that the CO2 sensor developed using this strategy has great potential for wearable respiratory monitoring applications.

A 4.26-μm RCLED and a fast low-power CO2 sensor

A Novel Solid State Non-Dispersive Infrared CO2 Gas Sensor Compatible with Wireless and Portable Deployment

A Light-Emitting Diode- (LED-) Based Absorption Sensor for Simultaneous Detection of Carbon Monoxide and Carbon Dioxide

High-Pressure Measurements of Temperature and CO2 Concentration Using Tunable Diode Lasers at 2 μm

An ultracompact refractive index gas-sensor based on photonic crystal microcavity

Highly Sensitive Optical Sensor Based on Two Cascaded Micro-Ring Resonators with an LED Light Source

A Low-Power, Low-Cost Infra-Red Emitter in CMOS Technology

Ultra-compact dual-channel integrated CO2 infrared gas sensor

Sensitive Carbon Monoxide Detection Based on Light Induced Thermoelastic Spectroscopy with a Hollow Waveguide and 2.3 Μm Diode Laser

Development of a Compact NDIR CO2 Gas Sensor for a Portable Gas Analyzer

A superlattice-based resonant cavity-enhanced photodetector operating in the long-wavelength infrared

Sensitive Carbon Monoxide Detection Based on Light-Induced Thermoelastic Spectroscopy with a Fiber-Coupled Multipass Cell [Invited]

Highly Sensitive CO2-LITES Sensor Based on a Self-Designed Low-Frequency Quartz Tuning Fork and Fiber-Coupled MPC

Real-time measurements of atmospheric CO using a continuous-wave room temperature quantum cascade laser based spectrometer

A Dual-Laser Sensor Based on Off-Axis Integrated Cavity Output Spectroscopy and Time-Division Multiplexing Method

Carbon monoxide gas detection system based on VCSEL using TDLAS technology

Photoacoustic Detection of CO2 Based on Mid-Infrared LED

Monolithically integrated mid-infrared sensor using narrow mode operation and temperature feedback

Integrated cavity output spectroscopy by using a sub-centimeter short optical cavity combined with a free-running Fabry–Perot diode laser

Mid-infrared all-fiber light-induced thermoelastic spectroscopy sensor based on hollow-core anti-resonant fiber

A Sensitive Carbon Monoxide Sensor Based on Photoacoustic Spectroscopy with a 2.3 μm Mid-Infrared High-Power Laser and Enhanced Gas Absorption