Abstract:Aluminum high pressure die casting (HPDC) technology has evolved in the past decades, enabling stronger and larger one-piece casting with significant part consolidation. It also offers a higher design freedom for more mass-efficient thin-walled body structures. For body structures that require excellent ductility and fracture toughness to be joined with steel sheet via self-piercing riveting (for instance, shock towers and hinge pillars, etc.), a costly T7 heat treatment comprising a solution heat treatment at elevated temperatures (450 Â°Câ€“500 Â°C) followed by an over-ageing heat treatment is needed to optimize microstructure for meeting product requirement. To enable cost-efficient mass production of HPDC body structures, it is important to eliminate the expensive T7 heat treatment without sacrificing mechanical properties. Optimizing die cast alloy chemistry is a potential solution to improve fracture toughness and ductility of the HPDC components. The present study intends to tailor the Mg and Cu additions for a new Al-Si-Cr type die casting alloy (registered as A379 with The Aluminum Association, USA) to achieve the desired tensile properties without using T7 heat treatment. It was found that Cu addition should be avoided, as it is not effective in enhancing strength while degrades tensile ductility. Mg addition is very effective in improving strength and has minor impact on tensile ductility. The investigated Al-Si-Cr alloy with a nominal composition of Al-8.5wt.%Si-0.3wt.%Cr-0.2wt.%Fe shows comparable tensile properties with the T7 treated AlSi10MnMg alloy which is currently used for manufacturing shock towers and hinge pillars.

Aluminum alloy for die-casting, having improved corrosion resistance

Mechanical properties and corrosion behavior of trace Cr-containing Al–9Si-1.2Cu-0.5 Mg casting alloy

High strength and ductility aluminium alloy processed by high pressure die casting

Effects of Cu Addition on the Microstructure and Properties of the Al–Mn–Fe–Si Alloy

A high-specific-strength and corrosion-resistant magnesium alloy

Effect of Ti on Microstructure and Mechanical Properties of Die-Cast Al-Mg-Zn-Si Alloy

An Investigation on the Improved Corrosion Resistance of Die Casting Mg-5Al-8Sn-1Sr-xCa Alloys

Zirconium-strontium composite micro-alloyed high-toughness corrosion-resistant low-silicon-content aluminum-silicon-copper cast aluminum alloy and preparation method

A New Recycled Al–Si–Mg Alloy for Sustainable Structural Die Casting Applications

Effects of magnesium and copper additions on tensile properties of Al-Si-Cr die casting alloy under as-cast and T5 conditions

Improved Strength and Enhanced Pitting Corrosion Resistance of Al-Mn Alloy with Zr Addition

Optimization of casting means and heat treatment routines for improving mechanical and corrosion resistance properties of A356-0.54Sc casting alloy

Effects of Adding Trace Modification Elements and Heat Treatment on the Strength and Toughness of AlSi8Cu2MgMn Alloy

High-strength high-ductility Mg-Al-Mn die-casting magnesium alloy containing lanthanum-cerium mixed rear earth

Towards development of a high-strength stainless Mg alloy with Al-assisted growth of passive film

Enhanced strength-ductility synergy in a rheo-diecasting semi-solid aluminum alloy

Heat-resisting Al-Cu-Mg aluminum alloy

Enhanced comprehensive performance via alloying and rheo-diecasting in a semi-solid Al–Si–Fe–Mg–Cu–Sr alloy

A novel die-casting Mg alloy with superior performance: Study of microstructure and mechanical behavior

Corrosion characteristics of a tungsten alloy die-casting mould material in molten aluminium alloy

A method for yield and cycle time improvements in Al alloy casting with enhanced conductivity steel for die construction