Abstract:REBCO coated conductors are now being used for building very high-field magnets with large electromagnetic stresses, both expected ones due to transport current × stresses and additional stresses resulting from the large screening currents inherent in wide tapes. Post mortem analyses of several recent test coils operated above 40 T show that significant conductor plastic deformation occurs, even for JBR stresses well below the ~1 GPa yield of the Hastelloy substrate of the conductor. To investigate these deformation mechanisms, conductors were unwound after coil test and carefully examined with respect to their length-wise Ic which revealed many areas of local damage. Regions of interest were examined by metallographic cross-section, Hall microscopy, magneto-optic imaging and scanning electronic microscopy. Important damage frequently occurred to the outer edges of pancakes in the coil ends, which were often plastically deformed over the whole turn circumference, especially when this outer edge was a slit edge. Internal conductor damage was also seen, especially delamination between the buffer and REBCO layers at slit edges. Careful sectioning of the tape at ~10 mm intervals showed that the plastic deformation of the turns was complex and variable around the turn circumference, with tape cross-sections that exhibited continuous shape change in the outer turns. The bending center line of tapes often shifted from the tape center line toward the edge closest to the coil center, indicating asymmetric effects of transport and screening current stresses across the conductor width. A surprising and vital result is that damage was prevalent when the slit edge was also the edge at which transport current flowed. This damage was absent when the transport current flowed at the not-slit edge, implying great sensitivity of the effect of screening current stresses to localized conductor damage.

Current Sharing in Spiral Copper-Plated Multifilament Coated Conductors

Effect of dynamic resistance reduction in spiral copper-plated multifilament coated conductors

Concurrent Flame Spread and Blow-Off over Horizontal Thin Electrical Wires

Investigation into the overcurrent failure and combustion characteristics of copper‐clad aluminum conductors

Study on Torsion Behavior of Superconducting Conductor on Round Core Cable

Ignition and Flame Propagation of Externally Heated Electrical Wires with Electric Currents

Mechanical Response of Conductor on Round Core (CORC) Cables Under Electromagnetic Force

Current Distribution in Superconducting Tapes During Fast Current Ramping Based on Modified Brandt's Method

Impact of strain and field ramp functional form on thermomagnetic instabilities in composite Nb3Sn wires with multi-filaments inside the superconducting coil

Stratification and Filamentation Instabilities in the Dense Core of Exploding Wires

Molten Thermoplastic Dripping Behavior Induced by Flame Spread over Wire Insulation under Overload Currents.

Analysis of Mechanical Properties of Each Layer of Superconducting Tape of Multi-Layer CORC Cable under Transverse Compression Load

Analysis of Heat Transfer During Flame Spread over Energized-Wire under High Currents

AC Losses of Copper Stabilized Multifilament YBCO Coated Conductors

Numerical study on the transport current distribution in the multi-layer CORC coil

Evidence for length-dependent wire expansion, filament dedensification and consequent degradation of critical current density in Ag-alloy sheathed Bi-2212 wires

Performance Degradation of Multi-Layer Spiral Cable During Manufacturing Procedure

Analyses of the plastic deformation of coated conductors deconstructed from ultra-high field test coils

Coupling losses and transverse resistivity of multifilament YBCO coated superconductors

Critical Current Survival in the YBCO Superconducting Layer of a Delaminated Coated Conductor

Current Distribution Mapping in Insulated (gd,y)bco Based Stabilizer-Free Coated Conductor after Ac Over-Current Test for R-Sfcl Application